Directed Directechs DB3 Kurulum Kılavuzu - Sayfa 5

Uzaktan Çalıştırıcı Directed Directechs DB3 için çevrimiçi göz atın veya pdf Kurulum Kılavuzu indirin. Directed Directechs DB3 18 sayfaları. Smart key for 2013 toyota highlander
Ayrıca Directed Directechs DB3 için: Kurulum Kılavuzu (20 sayfalar), Kurulum Kılavuzu (19 sayfalar), Manuel (6 sayfalar), Kurulum Kılavuzu (18 sayfalar), Kurulum Kılavuzu (19 sayfalar), Kurulum Kılavuzu (20 sayfalar), Kurulum Kılavuzu (19 sayfalar), Kurulum Kılavuzu (20 sayfalar), Kurulum Kılavuzu (10 sayfalar), Kurulum Kılavuzu (19 sayfalar), Kurulum Kılavuzu (19 sayfalar), Kurulum Kılavuzu (20 sayfalar), Kurulum Kılavuzu (20 sayfalar), Kurulum Kılavuzu (20 sayfalar), Kurulum Kılavuzu (10 sayfalar), Kurulum Kılavuzu (20 sayfalar), Kurulum Kılavuzu (20 sayfalar), Kurulum Kılavuzu (19 sayfalar), Kurulum Kılavuzu (20 sayfalar), Kurulum Kılavuzu (20 sayfalar), Kurulum Kılavuzu (18 sayfalar), Kurulum Kılavuzu (20 sayfalar), Kurulum Kılavuzu (19 sayfalar), Kurulum Kılavuzu (19 sayfalar), Kurulum Kılavuzu (18 sayfalar), Kurulum Kılavuzu (19 sayfalar), Kurulum Kılavuzu (20 sayfalar), Kurulum Kılavuzu (18 sayfalar), Kurulum Kılavuzu (19 sayfalar), Kurulum Kılavuzu (20 sayfalar), Kurulum Kılavuzu (20 sayfalar), Kurulum Kılavuzu (20 sayfalar), Kurulum Kılavuzu (18 sayfalar), Kurulum Kılavuzu (20 sayfalar), Kurulum Kılavuzu (19 sayfalar), Kurulum Kılavuzu (20 sayfalar), Kurulum Kılavuzu (18 sayfalar), Kurulum Kılavuzu (19 sayfalar), Kurulum Kılavuzu (20 sayfalar), Kurulum Kılavuzu (17 sayfalar), Kurulum Kılavuzu (20 sayfalar), Kurulum Kılavuzu (18 sayfalar)

Directed Directechs DB3 Kurulum Kılavuzu
OEM remote starter information
If the vehicle has an active OEM remote starter it will program into convenience only (no immobilizer bypass). The reason for this is to allow
aftermarket security to be installed while keeping the factory remote starter active. If you wish for the interface to control the remote start
sequence, perform one of the following:
If the vehicle is equipped with an Add-On Lexus/Toyota OEM remote starter:
Some Lexus/Toyota vehicles may have an Add-On remote starter. If the OEM unit is installed, whether Active or Inactive, it MUST be
permanently disconnected, as both modules cannot coexist. Refer to 'Physical OEM remote start locations" in the chart below and always
physically inspect and disconnect any OEM remote starter before programming any Directed products.
Physical OEM remote start locations
Make
Model
Toyota
Venza (Smart Key)
Lexus
RX 450h (Smart Key)
Lexus
RX 350 (Smart Key)
Toyota
4Runner (Smart Key)
Toyota
Sienna (Smart Key)
Lexus
HS 250h (Smart Key)
Prius
Prius (Smart Key)
Lexus
CT 200h
Lexus
GX 460 (Smart Key)
Toyota
Prius V (Smart Key)
If the vehicle is equipped with a BCM Enabled Lexus/Toyota OEM remote starter:
The vehicle does not have a physical remote starter and only one module can be programed at a time. In this case temporarily disable the
OEM remote start system using the following process:
1. Remove the fuse powering the OEM Remote Starter. See "OEM remote start fuse location"
2. Perform a "Soft reset" or "Hard reset".
3. Perform the "Module programming".
4. After programming is successful, re-insert the fuse powering the OEM Remote Starter.
OEM remote start fuse location
Make
Model
Lexus
CT 200h (Smart Key)
Lexus
GX 460 (Smart Key)
Lexus
RX 350 (Smart Key)
Lexus
RX 450h (Smart Key)
5
403.TL2 4.15 2019 Lexus GX 460 (Smart Key)
©2021 VOXX•DEI LLC. All rights reserved.
Behind glove box.
Behind glove box.
Behind glove box.
Behind glove box & passenger kick panel.
Behind glove box & passenger kick panel.
Behind glove box.
Under dash panel & driver kick panel.
Behind glove box.
Behind glove box.
Behind glove box.
Engine room relay box, left side of engine compartment.
Engine room relay box, left side of engine compartment.
Engine room relay box, left side of engine compartment.
Engine room relay box, left side of engine compartment.
OEM remote starter & connectors location
Fuse Location
Fuse Name
Fuse
Value
MAYDAY
10A
MAYDAY
7.5A
MAYDAY/TEL
7.5A
MAYDAY
7.5A