Clarke BJ300 Kullanıcı Talimatları - Sayfa 4
Elektrikli Alet Clarke BJ300 için çevrimiçi göz atın veya pdf Kullanıcı Talimatları indirin. Clarke BJ300 17 sayfaları. Biscuit jointer
Sayfayı Yazdır
GENERAL SAFETY PRECAUTIONS CONTINUED
•
ALWAYS keep your proper footing and balance at all times DO NOT over
reach. For best footing wear rubber soled footwear. Keep floor clear of oil,
scrap wood etc.
•
ALWAYS use recommended accessories, the use of improper accessories could
be hazardous.
•
NEVER operate the machine when under the influence of drugs, alcohol or
any medication.
•
NEVER leave the machine running unattended. Turn power OFF. Do not leave
the machine until it comes to a complete stop.
•
NEVER force the machine, it will do a better and safer job at the rate for which
it was designed.
•
NEVER use power tools in damp or wet locations or expose them to rain. Keep
your work area well illuminated. Do NOT use in explosive atmosphere (around
paint, flammable liquids etc.). Avoid dangerous environments.
•
ALWAYS guard against electric shock . Prevent body contact with earthed or
grounded surfaces (pipes, radiators etc.) Safety can be further be improved
by using a residual current device (RCD).
•
ALWAYS store the tool out of the reach of children, DO NOT allow children to
use the tool.
ADDITIONAL PRECAUTIONS FOR POWERTOOLS
•
ALWAYS wear ear protectors/defenders as the noise level of this machine can
exceed 91dB (A).
•
ALWAYS secure all work sufficiently using a vice or clamps. Do not use hands to
secure work as this would be extremely dangerous.
•
ALWAYS switch the machine OFF immediately the task is completed.
•
ALWAYS check that all adjusters, chuck keys and wrenches have been
removed BEFORE turning the tool ON.
•
ALWAYS ensure safety devices are in place and are working correctly, if not
DO NOT use the machine until rectified.
•
DO NOT use the machine if the electrical cable, plug or motor is in poor
condition.
•
DO NOT allow the ventilation slots in the machine to become blocked.
•
DO NOT touch the blade immediately after use, allow time to cool.
•
ALWAYS keep the mains cable well away from the blade and ensure an
adequate electrical supply is close at hand so that the operation is not
restricted by the length of the cable.
•
ALWAYS connect devices which are provided for dust extraction.
NOTE: Connecting such devices does not preclude the user from wearing a
mask to prevent the inhalation of dust particles.
- 3 -