Clarke CAT141 Kullanım ve Bakım Talimatları - Sayfa 9
Elektrikli Alet Clarke CAT141 için çevrimiçi göz atın veya pdf Kullanım ve Bakım Talimatları indirin. Clarke CAT141 17 sayfaları. Air impact wrench
Ayrıca Clarke CAT141 için: Kullanım ve Bakım Talimatları (17 sayfalar)
Sayfayı Yazdır
OPERATING THE IMPACT WRENCH
1. Locate the socket over the nut to
be tightened or loosened.
2. Squeeze the trigger to start the
wrench.
3. Release the trigger switch to stop
the wrench.
• The square drive shaft will
continue to rotate very briefly
after the trigger has been
released.
ADJUSTING THE POWER
1. To adjust the power, set the air
regulator to one of the 3 settings
available. (Setting 1-Low, 3 -High)
• These numbers are only for
reference and do not denote a
specific amount of power.
For maximum power when removing
stubborn nuts, turn the supply
regulator to its highest setting.
DISCONNECTING THE AIR SUPPLY
1. Do not disconnect the air supply hose until the compressor has been shut
down and the compressed air released.
2. Refer to the compressor instruction manual for the procedure to shut down
and vent the compressed air.
3. Once the pressure has been released, disconnect the air supply hose from
the air tool.
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
9