Clarke CPR2 Kullanım ve Bakım Talimatları - Sayfa 9

Elektrikli Alet Clarke CPR2 için çevrimiçi göz atın veya pdf Kullanım ve Bakım Talimatları indirin. Clarke CPR2 13 sayfaları. Oil free riveter

Sayfayı Yazdır

TROUBLESHOOTING

SYMPTOM

Tool runs at normal

speed but slows down

under any load.

Tool runs slowly. Air flows

weakly from exhaust.

Tool will not run. Air flows

freely from exhaust.

Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]

PROBLEM

1. Excessive pressure on

tip.

2. Motor parts worn.

3. Worn or sticking

mechanism due to

lack of lubricant.

1. Motor parts jammed

with gum/dirt.

2. Regulator in closed

position.

3. General airflow

blocked by dirt.

1. Motor vanes stuck

due to buildup of

foreign material.

SOLUTION

1. Reduce the force

applied

2. Return to Clarke dealer

for repair.

3. Drip air tool lubricating

oil into air inlet. Allow oil

to soak moving parts

before using.

1. Examine inlet air filter for

cleanliness.

2. Adjust regulator to open

position.

3. Operate tool in short

bursts.

1. Disconnect air supply

and rotate tool assembly

manually.

2. Try operating tool in

short bursts.

3. Tap motor housing gently

with a rubber mallet.

4. Drip a few drops of air

tool lubricating oil into air

inlet to soak moving

parts.