Clarke CPSB200B Kullanım ve Bakım Talimatları Kılavuzu - Sayfa 12
Elektrikli Alet Clarke CPSB200B için çevrimiçi göz atın veya pdf Kullanım ve Bakım Talimatları Kılavuzu indirin. Clarke CPSB200B 17 sayfaları. Pressurised sandblaster
Sayfayı Yazdır
AIR FILTER
DRAINING
Condensation will collect in the air
filter which must be drained manually.
1. Drain the air filter by pulling down
on the drain plug until all the water
comes out, see Fig 18.
CLEANING/REPLACING
1. Press the release catch and
unscrew the condensation
chamber, see Fig 19.
2. Unscrew the filter as shown in Fig
20 and wipe clean.
NOTE: Do not use harsh or abrasive
chemicals when cleaning
the condensation chamber.
3. Refit the condensation chamber.
REPLACING THE NOZZLE
After l0-l2 hours of blasting time the nozzle should be checked for wear. The
nozzle will wear out over time and should be replaced when the hole is no
longer round or the abrasive media does not flow smoothly through. To
replace the nozzle:
NOTE: Refer to page 14 for the following replacement parts.
1. Disconnect the sandblasting gun from the air hose.
2. Unscrew the nozzle adapter (38), located at the front of the gun.
3. Remove the old nozzle (37) and insert the new one.
• A pack of 4 replacement nozzles are available from your Clarke
dealer Part number 7640132.
Replace the nozzle adapter (38) and firmly screw it onto sandblasting gun.
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
Fig 20
12
Fig 18
Fig 19