Clarke METALWORKER CBS20 Orijinal Talimat Kılavuzu - Sayfa 6
Elektrikli Alet Clarke METALWORKER CBS20 için çevrimiçi göz atın veya pdf Orijinal Talimat Kılavuzu indirin. Clarke METALWORKER CBS20 17 sayfaları. Electric drill bit sharpener
Sayfayı Yazdır
TOOL SPECIFIC SAFETY RULES
1. Make sure that flammable materials or materials that may explode are
kept out of the immediate vicinity.
2. DO NOT overload the tool. Only use the device for its intended purpose.
3. Make sure you are positioned firmly and with a natural stance when
working with the tool.
4. Make sure the grinding stone and head assembly are correctly seated and
installed before switching on the tool.
5. Prevent overheating of the tool and the drill bit.
6. Guide the mains cable in such a way that it cannot be caught by the tool.
7. NEVER remove too much material in a single process. It is better to remove
small amounts in multiple processes.
8. The tool should only be operated by a single operator at any one time.
9. ALWAYS wait until the grinding stone has come to a standstill before
removing contamination, etc. from the working area/tool.
10. NEVER leave the tool to run unattended.
11. Only use grinding stones that are in perfect condition.
12. Remember that moving parts may be located behind ventilation and
venting slots.
13. Ensure that the ventilation slots are always free of obstructions.
14. Check the grinding stone before each use. DO NOT use the device if the
grinding stone is broken, has a crack or is damaged in any other way.
Handle and store the grinding stone with care.
15. Make sure that the grinding stone is correctly fitted and secured. Allow the
device to operate in idle for 30 seconds in a safe location. Immediately
stop the device if there are faults.
16. Symbols affixed to your device SHOULD NOT be removed or covered.
Information on the device that is no longer legible should be replaced
immediately.
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
6