Clarke Metalworker CDP101B Kullanım ve Bakım Kılavuzu - Sayfa 9
Elektrikli Alet Clarke Metalworker CDP101B için çevrimiçi göz atın veya pdf Kullanım ve Bakım Kılavuzu indirin. Clarke Metalworker CDP101B 19 sayfaları. 13mm drill press
Sayfayı Yazdır
ASSEMBLY
IT IS ADVISED THAT ASSISTANCE BE USED WHEN ASSEMBLING THIS MACHINE.
A. Column to the Base.
Bolt the column assembly to the base with the three M8
screws provided.
NOTE: Ideally, the base with column attached, should be
firmly bolted to a workbench, prior to the assembly of
other components.
B. Table to Column.
1.
Thread the Table Support Locking Handle into the
Table Support from the left hand side, and leave it
loose at this stage.
2.
Slide the Table Support, with Table, over the Column
and lower it so that it rests on the column support.
Nip up the Table Support Locking Handle (Fig. 1).
C. Head to Column.
NOTE: I t may be necessary to unscrew the Head Lock Set
Screws (A fig.2), to ensure they do not protrude
internally, as this would prevent the head from sliding
fully into position.
1.
With assistance, raise the Head, and locate it on top
of the Column, ensuring it slides home fully.
2.
Align the head with the base, and tighten down the
Head Lock Set Screws using the wrench provided,
to secure the head.
3.
Locate the three feed handles, and screw them
firmly into the hub of the feed shaft (Fig.3).
CAUTION!
Fig. 2
Fig. 3
9
Fig. 1