ALE TC Series Operatör El Kitabı - Sayfa 12

Yazıcı ALE TC Series için çevrimiçi göz atın veya pdf Operatör El Kitabı indirin. ALE TC Series 18 sayfaları.

Sayfayı Yazdır

The TC72-H has been specially built to be used with the

and TC18-H have been specially built to be used with the

fluid is likely to severely damage the hydraulic system.

Fitting a bottle of ink into the reservoir:

●

Using a craft knife (or a sharp blade), cut the round raised plastic dome on the top of

the ink bottle cap (Fig. 14). Turn the bottle up-side down and push into the reservoir

(Fig. 15).

Fig. 14: Cutting the plastic cap of the ink bottle

Switch the controller on. From this moment, the LCD screen will run through the

●

start up procedure. After a few seconds, the controller will emit some beeps. This is

an automatic set up, so there is nothing to do until the screen shows " Print msg : 01 "

and "***no text*** ". The default language is English on all new machines.

To change to the language required, press

●

until you select the language required, for example " Langue, Français". Enter by

. The screen will display " Impr. Mess: 01" "Pas de message". Please report

pushing

to the controller documentation for more information.

The controller needs to be adjusted to the print-head. To check this, press

●

you reach " Install settings "and press

configuration is not already selected, press the arrow down

configuration.

For the TC72: If the TC72 has an 80pL print-engine the configuration to select is

" 1xT72mm

For the

TC54

"1xT18mm "

Press

to validate.

●

Then the ink system needs to be purged of air.

TC series print-heads Operator Manual

Design • Print • Trace

80pL ". Otherwise the configuration to select is " 1xT72mm ".

the configuration to select is " 1xT54mm ", and for the TC18

BOBET7X ink and the TC54-H

ALE

BOB ink. Using any other

ALE

Fig. 15: fitting a bottle

and then press the arrow down

. LCD says " head config ". If your

07/07/2011

until

until you reach your