Zanussi ZBA22420SA Kullanıcı Kılavuzu - Sayfa 8
Buzdolabı Zanussi ZBA22420SA için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. Zanussi ZBA22420SA 12 sayfaları.
Ayrıca Zanussi ZBA22420SA için: Kullanıcı Kılavuzu (44 sayfalar), Kullanıcı Kılavuzu (48 sayfalar)
Sayfayı Yazdır
Problem
Water flows on the ground.
The temperature in the appliance
is too low.
The temperature in the appliance
is too high.
Replacing the lamp
Caution! Disconnect the plug from the mains
socket.
Remove the screw from
the lamp cover.
Remove the lamp cover
(refer to the illustration).
Replace the used lamp
with a new lamp of the
same power and specifi-
cally designed for house-
hold appliances (the maxi-
mum power is shown on
the lamp cover).
Install the lamp cover.
Tighten the screw to the
lamp cover.
Connect the plug to the
mains socket.
Open the door. Make sure
that the light comes on.
8
Possible cause
The melting water outlet does not flow
in the evaporative tray above the com-
pressor.
The temperature regulator is not set
correctly.
The temperature regulator is not set
correctly.
The door is not closed correctly.
The product temperature is too high.
Many products are stored at the same
time.
There is no cold air circulation in the
appliance.
Attach the melting water outlet to the
evaporative tray.
Set a higher temperature.
Set a lower temperature.
Refer to "Closing the door".
Let the product temperature decrease to
room temperature before storage.
Store less products at the same time.
Make sure that there is cold air circula-
tion in the appliance.
Closing the door
1.
Clean the door gaskets.
2.
If necessary, adjust the door. Refer to "Installation".
3.
If necessary, replace the defective door gaskets.
Contact the Service Center.
Solution
www.zanussi.com