Zanussi ZF 18/8 K Talimat Kitapçığı - Sayfa 6

Buzdolabı Zanussi ZF 18/8 K için çevrimiçi göz atın veya pdf Talimat Kitapçığı indirin. Zanussi ZF 18/8 K 11 sayfaları. Fridge-freezer zf 18/8 k

Sayfayı Yazdır

Door reversibility

Unplug the appliance from the power supply before
carrying out any work.
To reverse the doors, proceed as follows:
Remove the ventilation grille (D), which has a snap-in
fitting.
Remove the bottom hinge (E) by unscrewing the two
fixing screws.
Remove the bottom door by sliding it off the centre
hinge.
Remove the centre hinge (H).
Remove the top door by sliding it off the top pin (A).
Unscrew the top pin (A) and washer (B) from the top
hinge (C) and refit them on the opposite side.
Refit the top door.
Refit the centre hinge on the opposite side.
Refit the bottom door.
Refit the bottom hinge (E) on the opposite side, using
the two screws previously removed.
With the help of a tool, remove the small cover (F),
which blanks off the slot for the bottom hinge, from
the ventilation grille (D).
Fit cover (G), supplied with the appliance, into the
slot left open.
Snap the ventilation grille (D) back into place.
The doors can be aligned by adjusting both the middle
and top hinges.
The middle hinge (H) can be adjusted horizontally,
with the help of a tool, after having slackened the two
screws.
The top hinge is adjusted by slackening the nut (A)
with a 10 mm spanner and then proceeding as shown
in Fig. 3.

Electrical connection

Before plugging in, ensure that the voltage and
frequency shown on the serial number plate
correspond to your domestic power supply.
Voltage can vary by 6% of the rated voltage.
For operation with different voltages, a suitably sized
auto-transformer must be used.
The technical data is indicated in the rating plate on the left side inside the appliance.
6
TECHNICAL SPECIFICATION
E
F
D
F
D640
D427
H
D405
D419
Fig. 3
F
F
Fig. 4
C
B
A
Fig. 5
Fig. 6
GB