Zanussi ZFC 26/6 3D Talimat Kitapçığı - Sayfa 4

Buzdolabı Zanussi ZFC 26/6 3D için çevrimiçi göz atın veya pdf Talimat Kitapçığı indirin. Zanussi ZFC 26/6 3D 10 sayfaları. Fridge-freezer zfc 26/6 3d

Sayfayı Yazdır

INSTALLATION

Caution

If this appliance featuring magnetic door seals is to
replace an older appliance having a spring lock
(latch) on the door or lid, be sure to make that
spring lock unusable before you discard the old
appliance. This will prevent it from becoming a
death-trap for a child.

Location

Place the appliance away from all heat sources, such
as: radiators, heating stoves, direct sunlight, etc.
Best performance is obtained with ambient
temperature between +18 C and +43 C (class T);
+18 C and +38 C (class ST); +16 C and +32 C (class
N); +10 C and +32 C (class SN).
The class of your appliance is shown on its rating
plate.
Make sure that there is nothing at the back, at the
top and at the bottom of the appliance to obstruct
air circulation.
For a more efficient operation of the appliance, the
minimum distance between the top of the appliance
and other overhanging kitchen furniture, if any,
should be at least 100 mm (see Fig. - A).
However, the best solution would be that shown in
B with no overhanging furniture.
Two adjustable feet make it possible to accurately
level the appliance.
A
D042

Rear spacers

In the plastic envelope containing the Operating
Instructions are also included two wall spacers to be
fitted into the special openings provided on the back
of the appliance.
Push-fit the spacers into the openings, making sure
that arrow (A) is positioned as per Fig. and then
turn the spacers through 45 until they lock in
(arrow (A) in a vertical position).
4
Fig. 1
B
A
45°
D039

Electrical connection

Before you plug the appliance into an A.C. mains
supply, make sure that the voltage and frequency
shown on the rating plate correspond to your home
supply.
A 6% fluctuation above or below the rated voltage is
admissible.
To adapt the appliance to other voltages, use an
autotransformer having a minimum output of 500 VA.
Important
It is essential that the appliance be connected to an
efficient earth tap.
For this purpose the supply cable plug incorporates
a special earth contact.
If the sockets of your domestic wiring system are
not grounded, have the appliance connected to a
separate ground wire by a qualified electrician in
accordance with the existing safety regulations.
The manufacturer declines to accept any liability
should this safety rule not be observed.
This appliance complies with E.E.C. directive No. 87/
308 of 2.6.87 relative to radio interference
suppression.
This appliance complies with the following
E.E.C. Directives:
- 73/23 EEC of 19.2.73 (Low Voltage Directive) and
subsequent modifications;
- 89/336 EEC of 3.5.89 (Electromagnetic
Compatibility Directive) and subsequent
modifications.

Cleaning the interior

Before using the appliance for the first time, wash
the interior and all internal accessories with
lukewarm water and some neutral soap so as to
remove the typical smell of a brand-new product,
then dry thoroughly. Do not use detergents which
will leave an odour or abrasive powders on the
interior, as these will damage the finish.
Fig. 2