Zanussi ZI 718/9 K Talimat Kitapçığı - Sayfa 7

Buzdolabı Zanussi ZI 718/9 K için çevrimiçi göz atın veya pdf Talimat Kitapçığı indirin. Zanussi ZI 718/9 K 11 sayfaları.

Open both the appliance door and that of the

Fig. 9

kitchen unit to approx. 90°. Place the little plates

8mm

over the runners. Hold the doors of the appli-

ance and the unit together and mark the holes.

Remove the little plates and make the holes

PR34

with a diam. of 2 mm. Replace the little platee

over the runners and screw in the screws

Fig. 10

provided (3.5x16 mm).

For the alignment of the kitchen unit door, if

necessary, use the clearance size of the slotted

holes. At the end of the procedure, check that

the doors of the appliance and the kitchen unit

open properly.

PR35

Fig. 11

D734

Electrical connection

Before plugging in, ensure that the voltage and frequency shown on the serial number plate

correspond to your domestic power supply. Voltage can vary by ±6% of the rated voltage. For

operation with different voltages, a suitably sized auto-transformer must be used.

TECHNICAL SPECIFICATIONS

The technical data is indicated in the rating plate on the left side inside the appliance.