Zanussi ZO32N Talimat Kitapçığı - Sayfa 5

Buzdolabı Zanussi ZO32N için çevrimiçi göz atın veya pdf Talimat Kitapçığı indirin. Zanussi ZO32N 9 sayfaları.

Sayfayı Yazdır

Door reversibility

Unplug the appliance from the power supply

before carrying out the below-mentioned

operations.

Remove the ventilation grill (D).

Unscrew the bottom hinge (E).

Remove the freezer door by releasing it from

the middle hinge (H).

Unscrew the middle hinge.

Remove the fridge door by releasing it from the

top hinge pin (A).

Remove the pin and the washer (A+B) from the

top hinge (C), then mount these on the opposite

side, after having removed the plugs which

must be refitted on the other side.

Refit the fridge door.

Replace the middle hinge to the left hand side.

Replace the freezer door.

Screw down the bottom hinge (E) on the

opposite side by using the screws previously

removed.

Remove the plug (F) from the ventilation grill (D)

and replace it on the opposite side.

Re-assemble the ventilation grill (D).

Unscrew the handle. Refit it on the opposite

side.

The doors can be aligned by adjusting both the

middle and top hinges.

The middle hinge can be adjusted horizontally,

with the help of a tool, after having slackened

the two screws.

The top hinge is adjusted by slackening the nut

with a 10 mm spanner and then proceeding as

shown in the Figure.

Warning:

After having reversed the opening direction

of the doors check that all the screws are

properly tightened and that the magnetic

seal adheres to the cabine". If the ambient

temperature is cold (i.e. in Winter), the gasket

may not fit perfectly to the cabine". In that case,

wait for the natural fitting of the gasket or

accelerate this process by heating up the part

involved with a normal hairdrier.

Electrical connection

Before plugging in, ensure that the voltage and frequency shown on the serial number plate

correspond to your domestic power supply. Voltage can vary by ±6% of the rated voltage. For

operation with different voltages, a suitably sized auto-transformer must be used.

The technical data is indicated in the rating plate on the left side inside the appliance.

TECHNICAL SPECIFICATIONS

D736

PR24

PR185

D737

Fig. 3

Fig. 4

Fig. 5

Fig. 6