Zanussi ZR 60/LM Kullanım ve Bakım Talimatları - Sayfa 7
Buzdolabı Zanussi ZR 60/LM için çevrimiçi göz atın veya pdf Kullanım ve Bakım Talimatları indirin. Zanussi ZR 60/LM 8 sayfaları. Zanussi refrigerators instructions for the use and care
Ayrıca Zanussi ZR 60/LM için: Kullanım ve Bakım Kılavuzu (8 sayfalar), Kullanım ve Bakım Talimatları Kılavuzu (8 sayfalar)
Sayfayı Yazdır
Important
To guarantee a correct operation of the
appliance built into the kitchen unit, make
sure that the venting grille is always
unobstructed in order to ensure an
adequate circulation of air which is
required to properly cool the compressor
and the condenser.
2. - Kitchen unit recess height of 820 mm
The dimensions of the kitchen unit
recess, into which the appliance is
to be built-in, are shown in Fig. 5
Building the appliance into a kitchen
unit recess (Model ZR 60/LM).
To install the appliance in the kitchen
unit recess it is first of all necessary
to remove the worktop and then carry out
following operations (Fig. 6):
1) Remove the three screws fastening
hinge "A" as well as the three screws
on the other side of the panel and the two
screws "F".
Be ware to keep these six screws that will
be needed later on.
Take off kikplate "B".
2) Remove the four screws "C" and
unfasten the four screws "D". Take off the
two panels "E".
3) Fasten again the four screws "D".
4) Assemble kikplate supplied with the
appliance and hinge "A" using the six
screws removed on step 1.
5) Remove the levelling feet "G" and fit
them at the base of the cabinet.
Reducing height from 90 cm to 85 cm
(Fig. 6).
If you wish to reduce appliance height
from 90 cm to 85 cm, operate as described
in previous paragraph (only for
model ZR 60/LM).
| BO153
Fig. 6
7