Zanussi ZRA 626 CW Talimat Kitabı - Sayfa 40
Buzdolabı Zanussi ZRA 626 CW için çevrimiçi göz atın veya pdf Talimat Kitabı indirin. Zanussi ZRA 626 CW 48 sayfaları.
Sayfayı Yazdır
GB
Technical data
Model
Gross capacity (l)
Net capacity (l)
Width (mm)
Height (mm)
Depth (mm)
Energy consumption
Energy class, according to EU standards
Rated current (A)
Weight (kg)
Installing the appliance
Transportation, unpacking
It is recommended to deliver the appliance in original
packaging, in vertical position considering the
protective warning on packaging.
After each transportation the appliance must not be
switched on for approx. 2 hours.
Unpack the appliance and check if there are damages on
it. Report possible damages immediately to the place you
bought it. In that case retain packaging.
Cleaning
Remove every adhesive tape, which ensure the parts not to
move in the appliance.
Wash the inside of the appliance using lukewarm water and
mild detergent. Use soft cloth.
After cleaning wipe out the inside of the appliance.
Placement
The ambient temperature has an effect on the energy
consumption and proper operation of the appliance. When
placing, take into consideration that it is practical to operate
the appliance between ambient temperature limits
according to the climate class that is given in the chart
below and can be found in the data label.
Class of climate
SN
N
ST
If the ambient temperature goes below the lower data the
temperature of the cooling compartment can go beyond
the prescribed temperature.
40
Instructions for the Installer
(kWh/24h)
(kWh/year)
Ambient temperature
+10 ... +32 °C
+16 ... +32 °C
+18 ... + 38 °C
ZRA 626CW
Fresh food comp.: 253
Fresh food comp.: 236
550
1250
600
0,44
161
A
0,6
45
If the ambient temperature goes beyond the upper data this
means longer operating time of the compressor,
breakdown in the automatic defrosting increasing
temperature in the cooling compartment or increasing
energy consumption.
When placing the appliance ensure that it stands level. This
can be achieved by two adjustable feet (1) at the bottom in
front. 1-1 piece of distance washer (2) are accessories of
the adjustable feet. If levelling the appliance requires, these
washers can be removed.
The plastic bag of accessories also contains two
spacers to be fitted into special holes in the back of
the appliance. Fit the spacers into the holes, taking
care to ensure that the arrow (A) is positioned as
shown in Figure. Then turn them through 45° (arrow
(A) vertical) until they lock into place.
A
45°
PR60