Zanussi ZRB36104WA Kullanıcı Kılavuzu - Sayfa 3
Buzdolabı Zanussi ZRB36104WA için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. Zanussi ZRB36104WA 44 sayfaları.
Ayrıca Zanussi ZRB36104WA için: Kullanıcı Kılavuzu (29 sayfalar)
Sayfayı Yazdır
Do not use mechanical devices or other means to accelerate
•
the defrosting process, other than those recommended by the
manufacturer.
Do not damage the refrigerant circuit.
•
Do not use electrical appliances inside the food storage
•
compartments of the appliance, unless they are of the type
recommended by the manufacturer.
Do not use water spray and steam to clean the appliance.
•
Clean the appliance with a moist soft cloth. Only use neutral
•
detergents. Do not use abrasive products, abrasive cleaning
pads, solvents or metal objects.
Do not store explosive substances such as aerosol cans with a
•
flammable propellant in this appliance.
If the supply cord is damaged, it must be replaced by the
•
manufacturer, its service agent or similarly qualified persons in
order to avoid a hazard.
Safety instructions
Installation
WARNING!
Only a qualified person must install
this appliance.
• Remove all the packaging.
• Do not install or use a damaged appliance.
• Obey the installation instruction supplied
with the appliance.
• Always be careful when you move the
appliance because it is heavy. Always wear
safety gloves.
• Make sure the air can circulate around the
appliance.
• Wait at least 4 hours before connecting the
appliance to the power supply. This is to
allow the oil to flow back in the compressor.
• Do not install the appliance close to
radiators or cookers, oven or hobs.
• The rear of the appliance must stand against
the wall.
• Do not install the appliance where there is
direct sunlight.
• Do not install this appliance in areas that are
too humid or too colds, such as the
construction appendices, garages or wine
cellars.
www.zanussi.com
• When you move the appliance, lift it by the
front edge to avoid scratching the floor.
Electrical connection
WARNING!
Risk of fire and electrical shock.
• The appliance must be earthed.
• Make sure that the electrical information on
the rating plate agrees with the power
supply. If not, contact an electrician.
• Always use a correctly installed shockproof
socket.
• Do not use multi-plug adapters and
extension cables.
• Make sure not to cause damage to the
electrical components (e.g. mains plug,
mains cable, compressor). Contact the
Service or an electrician to change the
electrical components.
• The mains cable must stay below the level of
the mains plug.
• Connect the mains plug to the mains socket
only at the end of the installation. Make sure
that there is access to the mains plug after
the installation.
• Do not pull the mains cable to disconnect
the appliance. Always pull the mains plug.
3