Zanussi ZRG16605WA Kullanıcı Kılavuzu - Sayfa 9
Buzdolabı Zanussi ZRG16605WA için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. Zanussi ZRG16605WA 16 sayfaları.
Ayrıca Zanussi ZRG16605WA için: Kullanıcı Kılavuzu (48 sayfalar), Kullanıcı Kılavuzu (49 sayfalar)
Sayfayı Yazdır
Problem
If the advice does not lead to the
desired result, contact the nearest
Authorised Service Centre.
Replacing the lamp
Disconnect the plug from the mains socket.
1. Remove the screw from the lamp cover.
2. Remove the lamp cover (refer to the
illustration).
Installation
WARNING!
Refer to Safety chapters.
Positioning
This appliance can be installed in a dry, well
ventilated indoor where the ambient
temperature corresponds to the climate class
indicated on the rating plate of the appliance:
Climate
Ambient temperature
class
SN
+10°C to + 32°C
N
+16°C to + 32°C
ST
+16°C to + 38°C
T
+16°C to + 43°C
www.zanussi.com
Possible cause
The door has been opened of-
ten.
There is no cold air circulation
in the appliance.
3. Replace the used lamp with a new lamp of
4. Install the lamp cover.
5. Tighten the screw to the lamp cover.
6. Connect the plug to the mains socket.
7. Open the door.
Make sure that the light comes on.
Closing the door
1. Clean the door gaskets.
2. If necessary, adjust the door. Refer to
3. If necessary, replace the defective door
Rear spacers
You can find the two spacers in the bag with
documentation.
1. Release the screw.
2. Engage the spacer below the screw.
3. Turn the spacer to the right position.
4. Tighten again the screws.
Open the door only if necessary.
Make sure that there is cold air cir-
culation in the appliance.
the same power and specifically designed
for household appliances (the maximum
power is shown on the lamp cover).
"Installation".
gaskets. Contact the Authorised Service
Centre.
Some functional problems might
occur for some types of models
when operating outside of that
range. The correct operation can
only be guaranteed within the
specified temperature range. If you
have any doubts regarding where to
install the appliance, please turn to
the vendor, to our customer service
or to the nearest Authorised Service
Centre.
Solution
9