Zanussi ZT 56/2 R Talimat Kitapçığı - Sayfa 15

Buzdolabı Zanussi ZT 56/2 R için çevrimiçi göz atın veya pdf Talimat Kitapçığı indirin. Zanussi ZT 56/2 R 15 sayfaları. Zanussi instruction refrigerator zt 56/2 r
Ayrıca Zanussi ZT 56/2 R için: Talimat Kitapçığı (20 sayfalar)

Zanussi ZT 56/2 R Talimat Kitapçığı

Electrical Connection

WARNING:
THIS APPLIANCE MUST BE EARTHED.
The manufacturer declines any liability
should this safety measure not be
observed.
If the plug that is fitted to your appliance is not
suitable for your socket outlet, it must be cut off and
the appropriate plug fitted.
Remove the fuse from the cut off plug.
The cut off plug should then be disposed of to
prevent the hazard of shocks in case it should be
plugged into a 13amp socket in another part of your
home.
Important
The wires in the mains lead are coloured in
accordance with the following code:
Green and Yellow
Blue
Brown
If you fit your own plug, the colours of the wires in
the mains lead of your appliance, may not
correspond with the markings identifying the
terminals in your plug, proceed as follows:
Connect the Green and the Yellow (earth) wire to the
terminal in the plug which is marked with the letter
«E» or the earth symbol
yellow.
Connect the blue (neutral) wire to the terminal in the
plug which is marked with the letter «N» or coloured
black.
Connect the brown (live) wire to the terminal in the
plug which is marked with the letter «L» or coloured
red.
The plug moulded onto the lead incorporates a fuse.
For replacement, use a 13amp BS1362 fuse. Only
ASTA or BSI approved fuses should be used.
The plug must not be used if the fuse cover/carrier is
lost. The cover/carrier is indicated by the coloured
insert at the base of the plug.
A replacement cover/carrier must be obtained from
your local Electrolux Service Force Centre whose
address is listed in the Customer Care Booklet which
accompanies your instruction manual.
- Earth
- Neutral
- Live
, or coloured green and
This appliance complies with the E.E.C. Directive
No. 87/308 of 2.6.87 relative to radio interference
suppression.
This appliance complies with the following
E.E.C. Directive:
- 73/23 EEC of 19.2.73 (Low Voltage Directive)
and subsequent amendments.
- 89/336 EEC of 3.5.89 (Electromagnetic
- Compatibility Directive) and subsequent amend-
ments.
Please ensure that when the appliance is
installed it is easily accessible for the engineer in
the event of breakdown.
GREEN & YELLOW
BLUE
CORD CLAMP
D207
15
13 AMP. FUSE
BROWN