Zanussi ZU 7115 Talimat Kitapçığı - Sayfa 10
Buzdolabı Zanussi ZU 7115 için çevrimiçi göz atın veya pdf Talimat Kitapçığı indirin. Zanussi ZU 7115 16 sayfaları. Larder-refrigerator
Ayrıca Zanussi ZU 7115 için: Talimat Kitapçığı (20 sayfalar)
Sayfayı Yazdır
POWER SUPPLY VOLTAGE AND FREQUENCY
TOTAL POWER ABSORBED
AVERAGE DAILY UNITS ELECTRICITY *
GROSS CAPACITY
NET CAPACITY
*
This figure is based on standard test results in accordance with European Standard EN 153.
Actual consumption will depend on how the appliance is used and where it is located .
Setting the temperature
The temperature inside the refrigerator and
freezer is regulated by a single thermostat with
6 temperature positions and one «OFF» (O)
position.
Position 1 = minimum cold
Position 6 = maximum cold
Turn the thermostat dial to the required position;
the intermediate position is usually the most
suitable. The thermostat setting can vary as
the temperature inside the refrigerator
compartment depends on the following factors:
- room temperature
- how often the door is opened
- how much food is stored
- position of the appliance
Important
If the refrigerator is not defrosting correctly, it is
possible that because a very low temperature
has been selected and the motor is working
continuously, which prevents the defrost cycle
from operating.
To ensure correct defrosting, a lower number
should be selected on the thermostat and you
should notice that the motor cuts out from time
10
TECHNICAL SPECIFICATIONS
OPERATION
to time, which is correct.
If you wish to return to a lower temperature, turn
the thermostat to a higher number; however you
should turn the setting lower occasionally to
allow automatic defrosting.
220-240 V / 50 Hz
100 W
1,00 kWh
116 l
112 l
GB
GB