Zanussi ZU65 TR Kullanım ve Bakım Talimatları - Sayfa 8

Buzdolabı Zanussi ZU65 TR için çevrimiçi göz atın veya pdf Kullanım ve Bakım Talimatları indirin. Zanussi ZU65 TR 12 sayfaları.

Door reversal

directions (Rg 3 «

Before carrying out the operations

described below, pull out the mains plug

from the wall socket.

To carry out this reversal go through the

following steps:

Remove bottom hinge 6;

Remove door 5;

Unscrew pin 3 from the top hinge 2 and

refit it on the opposite side;

Unscrew part 7 and refit it on the

opposite side;

e) Refit the door and the bottom hinge

(into the holes already provided);

0 Remove handle 4 and refit it on the

opposite side (the fixing holes are

already provided).

Aligning the moulded plastic

worktop (Fig. 3)

The appliance comes with the worktop

aligned with the door.

To change the alignment, proceed as

follows:

remove the two screws A securing the

plate (1) at the rear, shift it forward to the

required position and then refit the two

fixing screws.

Aligning the laminated plastic

worktop (Fig. 4)

The 5.pphance comes with the worktop

aligned with the door.

To change the alignment, proceed as

follows;

Remove the two screws A;

Remove wall spacer 9 (which is push-

fitted) by pulling it out at both ends;

Slide out panel 1;

Remove the screws fixing frame 8 to

the cabinet and, after selecting the new

position, refit the frame and screw

down the previously removed screws;

e) Refit panel 1 and wall spacer 9;

fi Refit the two fixing screws A

Fig. 3

Fig'. 1