Clarke X-Pro CAT199 Kullanım ve Bakım Talimatları - Sayfa 8
Elektrikli Alet Clarke X-Pro CAT199 için çevrimiçi göz atın veya pdf Kullanım ve Bakım Talimatları indirin. Clarke X-Pro CAT199 17 sayfaları. 1/2" air ratchet wrench
Sayfayı Yazdır
OPERATION
SETTING THE DIRECTION OF ROTATION
WARNING: ALWAYS WAIT UNTIL THE DRIVE SHAFT HAS STOPPED ROTATING
BEFORE SETTING THE DIRECTION OF ROTATION.
To select the direction of rotation turn
the direction control as follows.
• For tightening bolts/nuts, turn
the direction control anti-
clockwise to F (Forward).
• For loosening bolts/nuts, turn the
direction control clockwise to R
(Reverse).
FITTING THE SOCKETS AND USING THE WRENCH
1. Select the socket required and
push it onto the square drive shaft.
• It clicks into place when secure.
2. Place the socket over the nut.
• Take care that the socket is
firmly engaged.
3. Squeeze the trigger against the
body of the tool to start.
4. Release the trigger to stop the tool.
5. ALWAYS ensure the tool has stopped before putting it down.
6. When releasing very tight fastenings initially break loose by hand. Squeeze
the trigger and the air tool will complete the job.
7. If necessary, use penetrating oil to assist in freeing off rusted fasteners.
8. When assembling, start turning fasteners by hand, then set the rotation
forward or reverse. Apply the tool gently and squeeze the trigger to tighten
with power.
9. Final tightening should be completed by hand to the required torque
values.
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
8