Zanussi ZX 57/3 SI Talimat Kitapçığı - Sayfa 4

Buzdolabı Zanussi ZX 57/3 SI için çevrimiçi göz atın veya pdf Talimat Kitapçığı indirin. Zanussi ZX 57/3 SI 10 sayfaları. Zanussi instruction booklet refrigerator- freezer zx 57/3 w, zx 57/3 sa, zx 57/3 si
Ayrıca Zanussi ZX 57/3 SI için: Talimat Kitapçığı (20 sayfalar), Talimat Kitapçığı (24 sayfalar), Talimat Kitapçığı (20 sayfalar)

Sayfayı Yazdır
Zanussi ZX 57/3 SI Talimat Kitapçığı
Remove all securing tapes. Wash inside the
appliance with lukewarm water and bicarbonate of
soda (5 ml to 0.5 litre of water).
A - Thermostat control knob
B - Pilot light
Allow the appliance to stand for 2 hours after
installation.
Plug in the appliance and switch on at the mains
supply. Turn the thermostat control (A) to a midway
setting (3-4) and adjust the slider control, situated on
the back wall of the fridge section, to a midway
position between "MIN" and "MAX". The pilot light (B)
will illuminate. Leave the appliance for approximately
4 hours for the correct temperature to be reached
before placing food inside.
To switch off the appliance turn the thermostat
G
control to position "
"
The temperature inside the appliance is regulated by
a thermostat with 6 temperature positions and an
G
"OFF" (
) position.
Position 1 = minimum coldness
Position 6 = maximum coldness
Turn the thermostat control knob to the required
position.
The thermostat control knob regulates the
temperature both within the fridge and the freezer
compartment. The thermostat setting can vary as the
temperature inside the appliance depends on the
following factors:
– room temperature
– how often the door is opened
– how much food is stored
– position of the appliance
4
6
1
5
2
4
3
B
A
Your appliance has an air circulation slider control
situated at the rear of the fridge compartment, which
controls the amount of cold air circulated through the
fridge compartment.
When the ambient temperature is between 10°C and
16°C, the slider control should be in the "MIN"
position.
When the ambient temperature is above 16°C the
slider control should be midway between "MIN" and
"MAX".
When the ambient temperature is very high (i.e. hot
summer days) position the slider control to "MAX".
MIN
MAX
COOL FLOW CONTROL
MIN
MAX
COOL FLOW CONTROL
D757/1