Clarke X-Pro CAT205 Kullanım ve Bakım Talimatları - Sayfa 10
Elektrikli Alet Clarke X-Pro CAT205 için çevrimiçi göz atın veya pdf Kullanım ve Bakım Talimatları indirin. Clarke X-Pro CAT205 17 sayfaları. 1/4” air ratchet wrench
Sayfayı Yazdır
DISCONNECTING THE AIR SUPPLY
1. DO NOT disconnect the air hose until the supply is isolated at a shut-off
valve.
2. Once the pressure has been isolated, disconnect the air supply hose from
the air tool.
3. Shut down the compressor at the end of the work session and drain daily as
recommended.
STORAGE
When not in use, disconnect from the air supply, clean & store in a safe, dry
place.
If the tool is to be stored or is idle for longer than 24 hours, run a few drops of
CLARKE air line oil into the air inlet and run the tool for 5 seconds in order to
lubricate the internal parts. When storing, replace the blanking plug on the
airline inlet.
Avoid storing the tool where the temperature is below 0
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
10
o
C.