Zanussi ZOF35802XK Kullanıcı Kılavuzu - Sayfa 18

Fırın Zanussi ZOF35802XK için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. Zanussi ZOF35802XK 25 sayfaları. Built-under double oven
Ayrıca Zanussi ZOF35802XK için: Kullanıcı Kılavuzu (25 sayfalar)

Zanussi ZOF35802XK Kullanıcı Kılavuzu

CATALYTIC CLEANING

CAUTION! Do not clean the catalytic
surface with oven sprays, abrasive
cleaning agents, soap or other
cleaning agents. This will damage the
catalytic surface.
Spots or discolouration of the catalytic
surface have no effect on catalytic
properties.
WARNING! Keep children away when
you clean the oven at a high
temperature. The oven surface
becomes very hot and there is a risk of
burns.
CAUTION! Always turn the oven light
on while using the catalytic cleaning (if
applicable).
Before activating the catalytic cleaning
remove all the accessories from the
oven.
The walls with a catalytic coating are self-cleaning.
They absorb fat which collects on the walls while
the appliance operates.
To support the self-cleaning procedure, heat the
empty oven on a regular basis.
1. Clean the oven floor with warm water and
washing up liquid, then dry it.
2. Set the function
3. Set the temperature to 250ºC and let oven
operate for 1 hour.
4. When the appliance is cool, clean it with a soft
and moist sponge.

REMOVING AND INSTALLING THE DOOR

You can remove the door and the internal glass
panels to clean it. The number of glass panels is
different for different models.
WARNING! Be careful when you
remove the door from the appliance.
The door is heavy.
1. Open the door fully.
2. Fully lift up the clamping levers (A) on the two
door hinges.
18
if applicable. If not, set
3. Close the door until it is at an angle of
approximately 45°.
4. Hold the door with one hand on each side and
pull it away from the appliance at an upwards
angle.
5. Put the door with the outer side down on a soft
cloth on a stable surface. This is to prevent
scratches.
6. Hold the door trim (B) on the top edge of the
door at the two sides and push inwards to
.
release the clip seal.
2
B
CAUTION! Rough handling of the
glass, especially around the edges of
the front panel, can cause the glass to
break.
7. Pull the door trim to the front to remove it.
8. Hold the door glass panels on their top edge
one by one and pull them up out of the guide.
A
45°
1
A