Zanussi ZOG11311 Kullanıcı Kılavuzu - Sayfa 15
Fırın Zanussi ZOG11311 için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. Zanussi ZOG11311 20 sayfaları.
Ayrıca Zanussi ZOG11311 için: Kullanıcı Kılavuzu (20 sayfalar)
Warning! The adjustment conditions for
this appliance are located on the label or
rating plate.
Warning! The manufacturer is not
responsible for damages caused by an
installation which does not agree with the
instructions in the manual.
Installation environment:
• This appliance is not connected to a combus-
tion products evacuation device.
• Only install the appliance in a room with suffi-
cient ventilation.
• Keep natural ventilation holes open or install a
cooker hood.
• There must be a 130 cm² minimum opening
in the built-in cabinet.
The use of a gas cooking appliance results in
the production of heat and moisture in the room
in which it is installed. Ensure that the kitchen is
well ventilated: keep natural ventilation holes
open or install a mechanical ventilation device
(mechanical extractor hood). Prolonged inten-
sive use of the appliance may call for additional
ventilation, for example opening a window, or
more effective ventilation, for example increas-
ing the level of mechanical ventilation where
present.
Gas connection
The gas supply ramp is on the rear side of the
control panel.
Warning! Do not use rubber flexible pipes.
Warning! Before the gas connection,
disconnect the mains plug from the
mains socket or deactivate the fuse in the
fuse box. Close the primary valve of the
gas supply.
www.zanussi.com
A
B
C
A) Flexible metallic
pipe
B) Gasket
C) Gas supply ramp
1. Do not fully move the oven into the built-in
cabinet (about 30 cm).
There are two connection modes:
a) Connection with flexible metallic pipe
(maximum 2 m):
• Put the supplied gasket between the
pipe and the gas supply ramp.
• Turn the pipe to the 1/2" gas supply
ramp.
b) Connection with rigid metallic pipe
(soft copper, minimum diameter: 8
mm):
• Use a male / female adapter (not
supplied) to install the nut and the
olive on the gas supply ramp.
• Put the pipe into the gas supply
ramp.
2. Use a 22 mm spanner to tighten the nuts.
Keep the gas supply ramp in correct posi-
tion, do not apply force on the gas supply
circuit.
3. Fully insert the appliance into the built-in
cabinet. See instructions in "Building-in the
appliance".
4. Check with the leak detection fluid if the
connection seal is made properly.
Warning! Do not use a flame to con-
trol for leaks!
D
A
E
B
C
A) Rigid metallic pipe
B) Nut
C) Olive
D) Male / female
adapter
E) Gas supply ramp
15