Zanussi ZOP38903 Kullanıcı Kılavuzu - Sayfa 19
Fırın Zanussi ZOP38903 için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. Zanussi ZOP38903 24 sayfaları. Product manaul
Ayrıca Zanussi ZOP38903 için: Kullanıcı Kılavuzu (24 sayfalar), Kullanıcı Kılavuzu (28 sayfalar)
Sayfayı Yazdır
Problem
The oven does not heat up. The
fan does not operate. The display
shows
or
.
The display shows an error code
that is not on this list.
It takes too long to cook the
dishes, or they cook too quickly.
Steam and condensation collect
on the food and in the oven.
If you cannot find a solution to the problem yourself, con-
tact your dealer or the service centre.
We recommend that you write the data here:
Model (MOD.)
Product number (PNC)
Serial number (S.N.)
Installation
Warning! Refer to "Safety information" chapter.
www.zanussi.com
Possible cause
The demo mode is activated.
There is an electronic fault.
The temperature is too low or too
high.
You left the dish in the oven for too
long.
1.
Deactivate the appliance.
2.
Press and hold the button
approximately two seconds. An
acoustic signal sounds.
3.
Press and hold the buttons
at the same time until the
acoustic signal sounds again and
the indicator goes out.
1.
Deactivate the appliance with the
house fuse or the safety switch in
the fuse box and activate it again.
2.
If the display shows the error code
again, contact the service centre.
• Adjust the temperature if necessary.
• Follow the advice in the manual.
Do not keep the dishes in the appliance
for longer than 15-20 minutes after the
cooking ends.
The necessary data for the service centre is on the rating
plate. The rating plate is on the front frame of the oven
cavity.
.........................................
.........................................
.........................................
Remedy
for
and
19