Zanussi 132973860 Kullanıcı Kılavuzu - Sayfa 26

Yıkayıcı Zanussi 132973860 için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. Zanussi 132973860 32 sayfaları. Zanussi washing machine user manual

Sayfayı Yazdır

The drain hose may be extended to a

maximum of 4 metres. An additional drain hose

and joining piece is available from your local

Service Force Centre. The joining piece must

have an internal diameter of 18mm.

2. Onto a sink outlet spigot.

If the outlet spigot has not been used before,

remove any blanking plug that may be in place.

Push the drain hose onto the spigot and secure

with a clip if required, ensure a loop is formed

in the drain hose (see diagram) to prevent

waste from the sink entering the washing

machine.

Important!

Before connecting the machine to new

pipework or to pipework that has not been

used for some time, run off a reasonable

amount of water to flush out any debris that

may have collected in the pipes.

If your drain hose

looks like this (see

below) you do not

require the «U» piece.

Just push the hose

firmly into the

standpipe.

Levelling

Level the washing machine by raising or

lowering the feet. The feet may be tight to

adjust as they incorporate a self locking nut,

but the machine MUST be level and stable.

machine during operation.

Some vibration is inevitable, especially if

mounted on a wooden floor.

Sprung wooden floors are particularly

susceptible to vibration. For advice, consult a

builder. If possible, always place the machine

on a solid floor.

Special conditions

If the floor is carpeted or covered with crumbly

or soft material, insert a rigid support base

under the feet to prevent noise, vibration or

displacement. The base should protrude a few

centimetres beyond the edges of the machine.

WARNING!

The machine should NOT be placed on deep

pile carpeting.

NOTE

Please ensure that when the appliance is

installed it is easily accessible for the engineer

in the event of a breakdown.

In the interest of the environment

Washing machines and dishwashers should be

connected to the FOUL drainage system, the

water will then be taken to a sewage works for

treatment before being discharged safely into a

river. It is essential that these appliances are

not connected to the surface water drainage

system as this water is discharged directly into

a river or stream and may cause pollution.

Any necessary

adjustment can be

made with a spanner.

Accurate levelling

prevents vibration,

noise and

displacement of the