Zanussi FJ 1033 Kullanıcı Kılavuzu - Sayfa 9

Yıkayıcı Zanussi FJ 1033 için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. Zanussi FJ 1033 37 sayfaları. Electrolux washing machine instruction booklet
Ayrıca Zanussi FJ 1033 için: Talimat Kitapçığı (36 sayfalar)

Sayfayı Yazdır

INSTALLATION INSTRUCTIONS

If you intend the drain hose

from the machine to empty

into a sink, make sure that the

sink is empty and that the plug

hole is not blocked.

the

machine

permanently plumbed in, hook

the end of the drain hose into

a standpipe installed for the

purpose.

The standpipe must have an

internal diameter of at least

30 mm (1 1/2 in), in order that

there is an air gap between the

drain hose and standpipe.

Make sure, that it is designed

in such a way, that the end of

the drain hose cannot be

covered with water.

Important: Before connecting

the

machine

new

pipework or to pipework that

has not been used for some

time, run off a reasonable

amount of water to flush out

any debris that may have

collected in the pipes.

Whether discharging into a

sink or a standpipe check

that the end of the drain hose

is neither too high nor too

low. The top of the curve in

the hose's end should be no

more than 90 cm (35.4") and

no less than 60 cm (23.6")

above floor level.

ELECTRICAL CONNECTION

WARNING:

THIS APPLIANCE

MUST BE EARTHED

The manufacturer declines any

liability should this safety

measure not be observed.

If the plug that is fitted to

your appliance is not suitable

for your socket outlet, it must

be cut off and the appropri¬

ate plug fitted.

The cut off plug should be

disposed of to prevent the

hazard of electric shocks in

case it should be plugged into

a 13 Amp socket in another

part of your home.

Important

The wires in this mains lead

are coloured in accordance

with the following code:

GREEN AND

YELLOW

- EARTH

BLUE

- NEUTRAL

BROWN

- LIVE

If you fit your own plug,

the colours of the wires in the

mains lead of your appliance

may not correspond with the

markings identifying the

terminals in your plug, this is

what you have to do:

Connect the green and

yellow (earth) wire to the

terminal in the plug which is

marked with the letter «E» or

the earth

-Ar symbol or

coloured green, or green and

yellow.

Connect the blue (neutral)

wire to the terminal in the

plug which is marked with

the letter «N» or coloured

black.

Connect the brown (live)

wire to the terminal which is

marked with the letter «L» or

coloured red.

The plug moulded on to the

cord incorporates a fuse. For

replacement, use a 13 Amp

BS 1362 fuse.

Only ASTA approved fuses

should be used.

The fuse cover/carrier must

be replaced in the event of

changing fuse.

The right fuse cover/carrier

colour is the one shown by

the coloured insert at the

base of the plug.

The plug must not be used

if the fuse cover/carrier is

lost.

A replacement cover/car¬

rier must be obtained from

Zanussi

Service

Agents

whose addresses are listed on

the attached «Zanussi Service

Force Directory» or you could

find your local agent by looking

in your telephone directory

under "Z".

This appliance complies with

E.E.C. directive no. 87/308 of

2.6.87 relative to radio inter¬

ference suppression.