Zanussi FJD 1266 W Talimat Kitapçığı - Sayfa 9

Yıkayıcı Zanussi FJD 1266 W için çevrimiçi göz atın veya pdf Talimat Kitapçığı indirin. Zanussi FJD 1266 W 27 sayfaları. Zanussi instructrion manual compact washer fjd 1266 w, fjd 1466 w, fjd 1466 s
Ayrıca Zanussi FJD 1266 W için: Talimat Kitapçığı (27 sayfalar), Talimat Kitapçığı (27 sayfalar)

Sayfayı Yazdır

The SKIP button is then used to cancel or advance the

programme to the required phase.

The SKIP button can only operate when the programme

is in pause.

A normal wash cycle consists of the following phases,

Wash - Rinses - Spin and is confirmed by the

illumination of the corresponding LED,s.

To select rinses & spin, the programme must be

paused, now press the SKIP button once, the wash LED

goes out.

To select spin only, the programme must be paused,

now press the SKIP button twice.

The wash & rinsess LED,s go out.

To select Drain the programme must be paused, now

press the SKIP button three times, the wash - rinses -

spin LED,s go out.

11 DELAY button

This button makes it possible to delay the starting of the

programme by up to 24 hours. The delay you have

selected is shown on the display for about 3 seconds;

afterwards, the duration of the programme reappears.

If the button OUTDOOR SPORTS has been pressed the

selected delay will correspond to the soak time. If no

delay time is selected the soak programme will last

about 30 minutes.

You must select this option after you have set the

programme and before you press the START/PAUSE

button.

The time value shown on the display will decrease by

one unit every hour.

You can change the delay time at any moment, before

you press the START/PAUSE button.

If you have already pressed the START/PAUSE button,

and you wish to change or cancel the delay time,

proceed as follows:

• set the washing machine to PAUSE by pressing the

START/PAUSE button;

• press the DELAY button until the display shows the

desired delay time or

• press the DELAY button once, to erase the delay time.

The display will indicate "0h".

• press the START/PAUSE button again.

Important!

The door will be locked throughout the delay time

(DOOR LOCKED light lit).

If you need to open the door, you must first set the

washing machine to PAUSE by pressing the

START/PAUSE button. After you have closed the door,

press the START/PAUSE button again.

12 Programme phase indicator

lights

When you select a programme, the lights relevant to the

phases that form the programme light up.

After you have started the programme, only the light

relevant to the phase that is currently being carried out

will remain lit.