Zanussi FJS 1025 W Talimat Kitapçığı - Sayfa 12

Yıkayıcı Zanussi FJS 1025 W için çevrimiçi göz atın veya pdf Talimat Kitapçığı indirin. Zanussi FJS 1025 W 29 sayfaları. Front-load washer

Sayfayı Yazdır

12. How to change a programme

during its cycle

Before you make any change, you must pause the

washing machine by pressing the START/PAUSE

button.

It is possible to change any phase before the programme

carries it out.

Changing the type of fabric or temperature is possible,

obviously, only during the washing phase. When you

make a change in these two parameters, the washing

machine will resume the cycle from the beginning.

If it is necessary to drain the water in order to change the

programme in progress, proceed as follows:

• PAUSE the machine by pressing the START/PAUSE

button;

• press the SKIP/RESET button repeatedly, until only

the DRAIN light remains lit;

• press the START/PAUSE button again.

When the water has been drained, the display shows a

blinking zero. You may now select a new programme

and press the START/PAUSE button to start it.

13. How to cancel a programme

during its cycle

To cancel a programme that is being carried out, first

pause the washing machine by pressing the

START/PAUSE button, then press the SKIP/RESET

button repeatedly, until the display shows three blinking

dashes.

14. How to open the door during

the cycle of a programme

You can open the door, after having set the washing

machine to PAUSE, provided the following conditions

exist:

• the washing machine is not in the heating phase

beyond 40°C;

• the level of the water is not high;

• the drum is not turning.

If these requirements are met, when you pause the

washing machine, the DOOR LOCKED light goes out

and the door can be opened.

Should it not be possible to open the door, and should it

be absolutely necessary to do so, switch the machine off

by pressing the ON/OFF button.

After approximately 3 minutes, you can open the door.

Pay attention to the level and temperature of the

water in the washing machine!

When you close the door and press the ON/OFF button

again, the washing machine will resume the programme

from the point where it had been interrupted.

15. End of programme

At the end of the programme, the washing machine

stops automatically, gives an audible signal, and displays

a blinking zero.

If you had selected the RINSE HOLD option, the

START/PAUSE button light flashes to indicate that the

water must be drained. The display shows a steadily lit

zero.

When the programme has been completed, a blinking

zero appears on the display and the audible signal is

given.

The DOOR LOCKED light goes out at once.

Press the SKIP/RESET button repeatedly to erase

the programme that has just been carried out. If you

omit to do this, the next time you switch the washing

machine on, the blinking zero will appear on the

display and you will hear the audible signal.

Note: when you switch the machine on, if you must

erase the previously performed programme, it is also

sufficient to press the FABRIC button and select a new

programme.

Press the ON/OFF button to switch the machine off. The

relevant light will go out.

Remove the laundry from the washing machine.

Check whether the drum is completely empty, by

rotating it with your hand. The purpose of this is to

prevent any items of laundry from remaining

accidentally in the drum, where they might get damaged

in a subsequent wash (e.g. by shrinking) or bleed colour

into another load of laundry.

We advise you to close the water supply tap and

disconnect the plug from the socket.

Leave the door ajar in order to air the washing machine.