Zanussi FJS 1072 HV Talimat Kitapçığı - Sayfa 7

Yıkayıcı Zanussi FJS 1072 HV için çevrimiçi göz atın veya pdf Talimat Kitapçığı indirin. Zanussi FJS 1072 HV 21 sayfaları. Washing machine fjs 1072 hv

Sayfayı Yazdır

Water inlet

Connect the water inlet hose to a tap with a 3/4"

thread after having inserted the small filter "A"

supplied with the machine.

The other end of the inlet hose which connects to

the machine can be turned in any direction.

Simply loosen the fitting, rotate the hose and

retighten the fitting, making sure there are no

water leaks.

The inlet hose must not be lengthened. If it is too

short and you do not wish to move the tap, you

will have to purchase a new, longer hose

specially designed for this type of use.

Water drainage

The end of the drain hose can be positioned in

three ways:

Hooked over the edge of a sink using the

plastic hose guide supplied with the machine.

In this case, make sure the end cannot come

unhooked when the machine is emptying.

This could be done by tying it to the tap with a

piece of string or attaching it to the wall.

In a sink drain pipe branch. This branch must

be above the trap so that the bend is at least

60 cm above the ground.

Directly into a drain pipe at a height of not less

than 60 cm and not more than 90 cm.

The end of the drain hose must always be

ventilated, i.e. the inside diameter of the drain

pipe must be larger than the outside diameter of

the drain hose.

The drain hose must not be kinked. Run it along

the floor; only the part near the drainage point

must be raised.

Electrical connection

This machine is designed to operate on a 220-

230 V, single-phase, 50 Hz supply.

Check that your domestic electrical installation

can take the maximum load required (2.2 kW),

also taking into account any other appliances in

use.

Connect the machine to an earthed socket.

The manufacturer declines any

responsibility for damage or injury

through failure to comply with the above

safety precaution.

P0003

P0022

P0023

P0021