Clarke 2090901 Kullanım ve Bakım Talimatları - Sayfa 9

Hava Kompresörü Clarke 2090901 için çevrimiçi göz atın veya pdf Kullanım ve Bakım Talimatları indirin. Clarke 2090901 20 sayfaları.

Sayfayı Yazdır
Clarke 2090901 Kullanım ve Bakım Talimatları
STARTING AND USING THE COMPRESSOR
First time startup
NOTE: For first time operation, do not connect the air hose or any tools and proceed
as follows:
1.
Start the engine, according to the instructions contained in the engine service
manual, and allow to run for 10 minutes.
2.
After a ten minute period, stop the
engine and attach an air hose to
the air outlet and the tool.
3.
Screw the pressure regulator fully
anticlockwise, then restart the
engine and allow presure to build
up in the receiver.
Screw the pressure regulator
clockwise until the pressure,
registered on the Pressure Gauge,
is 100psi.
At this point, check the system for air
leaks. If any are apparent, stop the
engine and operate the tool until the
air pressure is at zero, or open the
drain cocks before rectifying.
NOTE:
Air will blow off at the bleed hole when the pressure reaches 100psi,
which is the MAX. operating pressure.
4.
With the engine running, turn the pressure regulator so that your desired
pressure is registered on the gauge, and proceed to use the air tool in
accordance with the manufacturers instructions.
When starting subsequently, start the machine as follows:
1.
At the begining of the day, open the drain cocks (see Fig.1) and allow any
condensate to drain completely, then close the cocks.
2.
Connect the air hose to the air outlet and tool, and set the pressure regulator
to zero pressure (turned fully anticlockwise).
3.
Start the engine in accordance with the instructions contained in the engine
service manual, and allow pressure to build up.
4.
When the pressure in the receiver has built up and air blows off at the bleed
hole, turn the outlet pressure regulator clockwise so that the desired pressure is
registered on the pressure gauge and proceed to use the air tool/spray gun.
5.
Check for air leaks at the tool and connectors...as above, before proceeding.
- 9 -
Fig.2