Directed Security and Remote Start Kurulum Kılavuzu - Sayfa 13

Araba Alarmı Directed Security and Remote Start için çevrimiçi göz atın veya pdf Kurulum Kılavuzu indirin. Directed Security and Remote Start 20 sayfaları. Security and remote start

Sayfayı Yazdır

1. Wiring Diagram

7. Unlock Output

1 pulse: The unlock output pulses once

2 pulses: The unlock output pulses twice.

8. Lock Output

1 pulse: The lock output pulses once

2 pulses: The lock output pulses twice

9. Factory Alarm Disarm w/Trunk Release

On: the Factory Alarm Disarm wire will pulse as programmed when the Trunk release output is activated.

Off: the Factory Alarm Disarm wire will not pulse when the Trunk release output is activated.

10. Factory Alarm Disarm—

With Unlock: In the default setting the factory alarm is disarmed any time the button(s) controlling Unlock is pressed and when remote

start is activated.

Before Unlock: output to disarm the factory alarm activates before unlock and when remote start is activated.

Remote Start Only: output disarms the factory alarm before remote start is activated.

11. Factory Alarm Disarm Pulses

•

Single, Double: Selectable for a single or double-pulse for the vehicle's factory alarm disarm input requirements.

12. AUX 2 Validity

This wire provides a (-) 200mA output whenever the transmitter button(s) controlling AUX 2 is pressed. This output can be programmed to provide

the following types of outputs:

Validity: Output that will send a signal as long as the transmission is received.

Latched: Output that will send a signal when the AUX button is pressed and will continue until the same button(s) is pressed again.

Latched, reset with ignition: Similar to the latched output, this type of output turns on the first time the AUX button is pressed and turns off

the next time the same button is pressed. This type of output additionally stops and resets whenever the ignition is turned on and then off.

30 (60 or 90) second timed: Output that will send a continuous signal for 30,60 or 90 seconds.

•

Note: All auxiliary channel timed outputs can be programmed using the Bitwriter® (1-90 seconds).

13 AUX 2 Linking None

Linking None: Feature not enabled.

Arm: When programming to validity or timed output this can be programmed to activate when arming

Disarm: When programming to validity or timed output this can be programmed to activate when disarming

Remote Start: When programming to validity or timed output this can be programmed to activate when remote starting with the transmit-

ter.

2-14 Aux 3 Validity(1)/Latched(2)/Latched Reset With Ignition(3)/30(4),60(5) And 90(6) Sec Timed Output:

AUX 3 can be programmed for these output configurations. The unit is set to the default validity output. To change the configuration, use the

two-chirp setting to toggle through the different configurations. Refer to feature 12 for additional detail.

2-15 Aux 3 Linking None(1)/Arm(2), Disarm(3), Remote Start(4): Refer to feature 13 for additional detail.

2-16 Aux 4 Validity(1)/Latched(2)/Latched Reset With Ignition(3)/30, 60 And 90 Sec Timed Output:

AUX 4 can be programmed for these output configurations. The unit is set to the default validity output. To change the configuration, use the

two-chirp setting to toggle through the different configurations. Refer to feature 12 for additional detail.

2-17 Aux 4 Linking None(1)/Arm(2), Disarm(3), Remote Start(4): Refer to feature 13 for additional detail.