Directed Security and Remote Start Kurulum Kılavuzu - Sayfa 19

Araba Alarmı Directed Security and Remote Start için çevrimiçi göz atın veya pdf Kurulum Kılavuzu indirin. Directed Security and Remote Start 20 sayfaları. Security and remote start

Sayfayı Yazdır

1. Wiring Diagram

cranking time.

Was the Tach Learn successful? The LED must light solid and bright to indicate a successful learn.

Make sure that there is a tach signal at the purple/white tach input wire of the remote start. If there is not a tach signal, recheck the

connection to the vehicle's tach wire and make sure the wire is not broken or shorted to ground leading to the remote start.

Is an ignition or accessory output wire connected to the starter wire of the vehicle? Verify the color of the starter wire in the vehicle

and confirm that an ignition or an accessory output is not connected to that wire.

The vehicle starts, but will only run for 10 seconds

Is the remote start programmed for voltage sense? If this does not work, a tach wire should be used.

Check shutdown diagnostics.

The climate control system does not work while the unit is operating the vehicle.

Either the wrong accessory wire is being energized or more than one igni tion or accessory wire must be energized in order to oper-

ate the climate control system.

If the vehicle has an electronic climate control system some will reset when the key is turned off and then back on, unfortunately this

is a function of the vehicle and cannot be bypassed.