Zanussi ZSF 4143 Kullanıcı Kılavuzu - Sayfa 19
Bulaşık Makinesi Zanussi ZSF 4143 için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. Zanussi ZSF 4143 24 sayfaları.
Sayfayı Yazdır
So that you always have these numbers at
hand, we recommend you to make a note of
them here:
The dishes are not clean
The dishes are wet and dull
There are streaks, milky spots or a bluish coating on
glasses and dishes
Water drops have dries onto glasses and dishes
If after all these checks, the problem persists,
contact your local Service Force Centre.
Technical data
Dimensions
Electrical connection
Voltage - Overall power - Fuse
Water supply pressure
Capacity
The wash results are not satisfactory
• The wrong washing programme has been selected.
• The dishes are arranged in such a way as to stop
• The spray arms do not rotate freely due to incorrect
• The filters in the base of the washing compartment
• Too little or no detergent has been used.
• Where there are limescales deposits on the dishes;
• The drain hose connection is not correct.
• The salt container cap is not properly closed.
• Rinse aid was not used.
• The rinse aid dispenser is empty.
• Decrease rinse aid dosing.
• Increase rinse aid dosing.
• The detergent may be the cause. Contact the de-
Width x Height x Depth (cm)
Information on the electrical connection is given on the rating plate on the
inner edge of the dishwasher's door.
Minimum - Maximum
place settings
Mod. : . . . . . . . . . . . . . . . . . . . . . . .
PNC :. . . . . . . . . . . . . . . . . . . . . . . .
S.N. : . . . . . . . . . . . . . . . . . . . . . . . .
water reaching all parts of the surface. The baskets
must not be overloaded.
arrangement of the load.
are dirty or incorrectly positioned.
the salt container is empty or the incorrect level of
the water softener has been set.
tergent manufacturer's consumer care line.
45 x 85 x 63
0,05 - 0,8 (MPa)
0,5 - 8 (bar)
9
19