Zanussi ZT 415 Talimat Kitapçığı - Sayfa 4

Bulaşık Makinesi Zanussi ZT 415 için çevrimiçi göz atın veya pdf Talimat Kitapçığı indirin. Zanussi ZT 415 20 sayfaları. Zanussi instruction booklet dishwasher zt 415

Sayfayı Yazdır

INSTALLATION

Remove all packaging before positioning the

machine.

Positioning

If possible, position the machine next to a water tap

and a drain.

The dishwasher features fill and drain hoses which

can be turned either to the left or the right to suit the

installation .

Levelling

Good levelling is essential for correct closure and

sealing of the door.

When the appliance is correctly levelled, the door will

not catch on the spacers on either side of the cabinet.

IN11

If the door does not close correctly, loosen or tighten

the adjustable support feet, until the machine is

perfectly level.

Water Supply Connections

This dishwasher must be permanently plumbed into a

cold water supply.

The water pressure must be within the limits given in

the technical specifications, as it will not function cor-

rectly if pressure is outside these specifications.

Your local Water Authority will advise you on the average

mains pressure in your area.

Where the water is supplied via a cold water storage

cistern, you can work out the pressure yourself by mea-

suring the vertical distance (or «head») between the

machine's inlet hose and the outlet from the cold water

storage cistern, allowing roughly 1 psi for every 2 feet.

For making the connection

itself, the coupling nut fitted

to the machine's supply

hose is designed to screw

onto either a 3/4 inch gas

thread spout, or to a pur-

pose made quick-coupling

tap such as the Press

Block.

CA04

IN12

PIN07GB

CA06

Caution: the retaining ring must be correctly fitted to

avoid water leaks.

Avoid bends or kinks in the hose which could prevent

or slow down the flow of water.

If the machine is connected to new pipes or pipes

which have not been used for a long time, you are

advised to run the water for a few minutes before

connecting the inlet hose. This will prevent deposits of

sand or rust clogging the inlet hose filter.

Water Outlet Connection

The end of the drain hose can be connected as

follows:

to the sink outlet siphon, securing it if necessary with

a clip;

to a wall outlet provided with vent-hole, minimum

internal diameter 4 cm;

The waste connection must be at a height of between

30 cm (minimum) and 100 cm (maximum) from the

floor.

CS05

It makes no difference which way the drain hose

faces, either to the right or left of the dishwasher.

Avoid bending or kinking the hose as this could

prevent or slow down the discharge of water.

If you use a drain hose extension it must be no longer

than 2 metres and its internal diameter must be no

smaller than the diameter of the hose provided.

Likewise the internal diameter of the couplings used

for connection to the waste outlet must be no smaller

than the diameter of the drain hose.

Note: The sink plug must not be in place when the

machine is draining as this could cause the water to

siphon back into the machine.

To make this easier, the

hose itself may be turned to

the left or the right. In either

case, be sure to incorporate

the strainer (A) supplied

with the machine into the

joint. See picture.

+ 2 m max