Zanussi ZBG 503 G Talimat Kitapçığı - Sayfa 4
Hob Zanussi ZBG 503 G için çevrimiçi göz atın veya pdf Talimat Kitapçığı indirin. Zanussi ZBG 503 G 22 sayfaları. Gas hobs
Ayrıca Zanussi ZBG 503 G için: Talimat Kitapçığı (12 sayfalar), Talimat Kitapçığı (12 sayfalar)
Sayfayı Yazdır
INSTALLATION
It is mandatory that all operations required for the
installation are carried out by a Competent Gas
Installer (CORGI registered installers normally meet
this criteria), and in accordance with existing rules
and regulations.
The relevant instructions are to be found in the
separate installation manual.
ELECTRICAL CONNECTIONS
WARNING: THIS APPLIANCE
MUST BE EARTHED.
The manufacturer declines to accept any liability
should this safety measure not be observed.
If the plug fitted to your appliance is not suitable for
the socket outlet, it must be cut off and the
apprioriate plug must be fitted.
The cut off plug should be disposed of to prevent the
hazard of electric shocks, should it be plugged into a
13 Amp socket in another part of your home.
IMPORTANT
The wires in this mains lead are coloured in
accordance with the following code:
Green and Yellow
Blue
Brown
If you fit you own plug, the colours of the wires in the
mains lead of your appliance may not correspond
with the markings identifying the terminals in your
plug. Proceed as follows:
-
connect the green and yellow wire (earth wire) to
the terminal in the plug which is marked with the
letter 'E' or the earth symbol or coloured green, or
green and yellow;
-
connect the blue wire (neutral) to the terminal in
the plug which is marked with the letter 'N' or
coloured black;
-
connect the brown wire (live) to the terminal in the
plug which is marked with the letter 'L' or coloured
red.
- Earth
- Neutral
- Live
Please, ensure that, once the appliance is installed, it
is easily accessible for the engineer in the event of a
breakdown.
WHEN THE HOB IS FIRST INSTALLED
Once the hob has been installed, it is important to
remove any protective materials, which were put on
in the factory.
The plug moulded on to the lead incorporates a fuse.
For replacement, use a 3 Amp BS1362 fuse. Only
ASTA/BSI approved fuses should be used. The fuse
cover/carrier must be replaced in the event of
changing a fuse.
The plug must not be used if the fuse cover/carrier is
lost.
A replacement cover/carrier must be obtained from
your local Zanussi Service Force Centre whose
address and telephone number is listed in the
directory toward the back of this instruction book, or
you can find your local service centre by looking in
your telephone directory under 'Z'.
FO 0390
5