Zanussi ZBG 509 SS Talimat Kitapçığı - Sayfa 4

Hob Zanussi ZBG 509 SS için çevrimiçi göz atın veya pdf Talimat Kitapçığı indirin. Zanussi ZBG 509 SS 9 sayfaları. Zanussi instruction gas hob zbg 509 ss

Sayfayı Yazdır

INSTALLATION

It is mandatory that all operations required for the

installation are carried out by a Competent Gas

Installer (CORGI registered installers normally meet

this criteria), and in accordance with existing rules

and regulations.

The relevant instructions are to be found in the

separate installation manual.

ELECTRICAL CONNECTIONS

WARNING: THIS APPLIANCE

MUST BE EARTHED.

The manufacturer declines to accept any liability

should this safety measure not be observed.

If the plug fitted to your appliance is not suitable for

the socket outlet, it must be cut off and the

apprioriate plug must be fitted.

The cut off plug should be disposed of to prevent the

hazard of electric shocks, should it be plugged into a

13 Amp socket in another part of your home.

IMPORTANT

The wires in this mains lead are coloured in

accordance with the following code:

Green and Yellow

Blue

Brown

If you fit you own plug, the colours of the wires in the

mains lead of your appliance may not correspond

with the markings identifying the terminals in your

plug. Proceed as follows:

connect the green and yellow wire (earth wire) to

the terminal in the plug which is marked with the

letter 'E' or the earth symbol or coloured green, or

green and yellow;

connect the blue wire (neutral) to the terminal in

the plug which is marked with the letter 'N' or

coloured black;

connect the brown wire (live) to the terminal in the

plug which is marked with the letter 'L' or coloured

red.

- Earth

- Neutral

- Live

Please, ensure that, once the appliance is installed, it

is easily accessible for the engineer in the event of a

breakdown.

WHEN THE HOB IS FIRST INSTALLED

Once the hob has been installed, it is important to

remove any protective materials, which were put on

in the factory.

The plug moulded on to the lead incorporates a fuse.

For replacement, use a 3 Amp BS1362 fuse. Only

ASTA/BSI approved fuses should be used. The fuse

cover/carrier must be replaced in the event of

changing a fuse.

The plug must not be used if the fuse cover/carrier is

lost.

A replacement cover/carrier must be obtained from

your local Zanussi Service Force Centre whose

address and telephone number is listed in the

directory toward the back of this instruction book, or

you can find your local service centre by looking in

your telephone directory under 'Z'.

FO 0390