Zanussi ZEE6940 Kullanıcı Kılavuzu - Sayfa 10

Hob Zanussi ZEE6940 için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. Zanussi ZEE6940 16 sayfaları. Product manaul
Ayrıca Zanussi ZEE6940 için: Kullanıcı Kılavuzu (36 sayfalar), Kullanıcı Kılavuzu (48 sayfalar), Kullanıcı Kılavuzu (40 sayfalar), Kullanıcı Kılavuzu (12 sayfalar)

Sayfayı Yazdır

ble section is applicable to the voltage load and

the working temperature.

The wires in the cord are coloured as follows:

Green and yellow

Blue

Brown

1. Remove the mains terminal cover plate

from the bottom side of the hob to uncover

the mains terminal block.

2. Loosen the two cable clamp screws and lift

the top side of the clamp so the cable can

go through it.

3. Connect the green and yellow (earth) wire

to the terminal which is marked with the

number 5 or the letter 'E', or the earth sym-

bol

, or coloured green and yellow. (see

Figure 1)

4. Connect the blue (neutral) wire to the ter-

minal which is marked with the number 4

or the letter 'N' or coloured blue. (see Fig-

ure 1)

5. Connect the brown (live) wire to the termi-

nal which is marked with the number 1, the

letter 'L'. It must always be connected to

the network phase. (see Figure 1)

Figure 1

1 2 3 4 5

There must be no cut or stray strands of wire

present. The cord clamp must be correctly at-

tached to the outer sheath.

Connection

Appliance control cir-

cuit

- Earth

- Neutral

- Live

Min. size ca-

Fuse

ble / flex

6 mm²

30 A

The yellow / green earth wire (B) must be

approximately 2 cm longer than the live

and neutral wire (A).

6. Secure the cable by means of the clamp

screws and refit the terminal block cover.

Important! According to the current

regulations only a qualified electrician or

competent person can replace the mains cable.

Building In

min. 600 mm

min. 450 mm

min. 55 mm

30 mm

10 mm

3 mm

A) supplied seal

B) supplied brackets

min. 650 mm

560 mm

11 mm