Zanussi ZES63 Kullanım Talimatları Kılavuzu - Sayfa 11
Hob Zanussi ZES63 için çevrimiçi göz atın veya pdf Kullanım Talimatları Kılavuzu indirin. Zanussi ZES63 21 sayfaları. Electric hob
Sayfayı Yazdır
Maintenance and Cleaning
Before any maintenance or cleaning
can be carried out, you must
DISCONNECT the hob from the
electricity supply.
This appliance cannot be cleaned with
steam or with a steam cleaning
machine.
The hob is best cleaned whilst it is still warm,
as spillage can be removed more easily than if it is
left to cool.
The Hob Top
Regularly wipe over the hob top using a soft
cloth well wrung out in warm water to which a little
washing up liquid has been added. Avoid the use
of the following:
-
household detergent and bleaches;
-
impregnated pads unsuitable for non-stick
saucepans;
-
steel wool pads;
-
bath/sink stain removers.
Should the hob top become heavily soiled, the
following products are recommended:
-
For stainless steal hobs use a proprietary
stainless steel cleaner.
-
For other hobs use Hob Brite or Bar Keepers
Friend.
The control knobs may be removed by
carefully pulling them upward for easier cleaning.
The Hotplates
Spills onto the actual plate should be removed
using warm water and a soft brush, nylon or
plastic scourer. To keep the plates looking as new,
hotplate conditioner can be purchased from most
hardware stores, e.g. "4 Hob" by HomeCare
Products (follow the manufacturer's instruction for
use).
Alternatively, wipe the plates with a drop of
olive oil on a kitchen towel to avoid rust. It is
important to note that the plate will smoke a little and
produce a slightly unpleasant odour when next
used.
Stainless steel parts: the stainless steel spill
rings may become straw coloured with use. Use a
proprietary stainless steel cleaner to remove this
straw discolouration. This also applies to the area
around the hotplates on stainless steel hobs.
Do not leave acid or alkaline
substances (e.g. vinegar, salt, lemon
juice, etc.) on the cooktop.
Failure to clean and condition hotplates
may lead to rust and corrosion forming on
the surface.
11