Zanussi ZGF 7820 Talimat Kitapçığı - Sayfa 5

Hob Zanussi ZGF 7820 için çevrimiçi göz atın veya pdf Talimat Kitapçığı indirin. Zanussi ZGF 7820 20 sayfaları. Zanussi instructrion manual gas range zgf 7820

Sayfayı Yazdır

Operation

Hob burners

To light a burner:

push in the relevant control knob and turn it

anticlockwise to maximum position;

then adjust the flame as required.

If the burner does not ignite, turn the control knob to

zero, and try again.

To ensure maximum burner efficiency, you should only

use pots and pans with a flat bottom fitting the size of

the burner used (see table).

Burner

Ultra-rapid

(triple-crown)

Large (rapid)

Medium (semi-rapid)

Small (auxiliary)

If you use a saucepan which is smaller than

the recommended size, the flame will spread

beyond the bottom of the vessel, causing the

handle to overheat.

Take care when frying food in hot oil or fat,

as the overheated splashes could easily ignite.

As soon as a liquid starts boiling, turn down the

flame so that it will barely keep the liquid

simmering.

If the control knobs become difficult to turn, please

contact your local Zanussi Service Force Centre.

Maintenance and Cleaning

Before any maintenance or cleaning can be carried

out, you must DISCONNECT the hob from the

electricity supply.

The hob is best cleaned whilst it is still warm, as

spillage can be removed more easily than if it is

left to cool.

The Hob Top

Regularly wipe over the hob top using a soft cloth well

wrung out in warm water to which a little washing up liquid

has been added. Avoid the use of the following:

household detergent and bleaches;

impregnated pads unsuitable for non-stick saucepans;

steel wool pads;

bath/sink stain removers.

Should the hob top become heavily soiled, it is

recommended that a cleaning product such as Hob Brite

or Bar Keepers Friend is used.

minimum

maximum

diameter

180 mm

260 mm

180 mm

260 mm

120 mm

220 mm

80 mm

160 mm

inserire

termocoppie

Fig. 1

The Burners

The burner caps and crowns can be removed for cleaning.

Wash the burner caps and crowns using hot soapy water,

and remove marks with a mild paste cleaner. A well

moistened soap impregnated steel wool pad can be used

with caution, if the marks are particularly difficult to

remove.

After cleaning, be sure to wipe dry with a soft cloth.

A - Burner cap

B - Burner crown

C - Ignition electrode