Zanussi ZGG67412 Kullanıcı Kılavuzu - Sayfa 10

Hob Zanussi ZGG67412 için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. Zanussi ZGG67412 16 sayfaları.
Ayrıca Zanussi ZGG67412 için: Kullanıcı Kılavuzu (16 sayfalar), Kullanıcı Kılavuzu (32 sayfalar)

Sayfayı Yazdır

than 20 m³), but not in a bathroom or shower

room.

The minimum distance combustible material can

be fitted above the hob in line with the edges of

the hob is 400 mm. If it is fitted below 400 mm

a space of 50 mm must be allowed from the

edges of the hob.

For appliances installed in the Republic of Ire-

land please refer to NSAI- Domestic Gas Instal-

lation I.S 813 Current Edition Section 7- Per-

mitted Locations of Appliance.

Gas Connection

Warning! Any gas installation must be

carried out by a GAS SAFE REGISTER

installer.

Make sure that, once the hob is installed, it is

easily accessible for the engineer in the event of

a breakdown.

The manufacturer will not accept liability, should

the above instructions or any of the other safety

instructions incorporated in this instruction

booklet be ignored.

On the end of the shaft, which includes the G

1/2" threaded elbow, adjustment is fixed so that

the washer is fitted between the components as

shown in the diagram. Screw the parts together

without using excessive force.

B C

A) End of shaft with nut

B) Washer

C) Elbow

Connection to the gas supply should be with ei-

ther rigid or semi-rigid pipe, i.e. steel or copper.

The connection should be suitable for connect-

ing to R 1/2 (1/2 BSP male thread).

When the final connection has been made, it is

essential that a thorough leak test is carried out

on the hob and installation.

Make sure that the main connection pipe does

not exert any strain on the hob.

If you use flexible metal pipes make sure that

they agree to ISO 10380 and ISO 10807

standards. Be careful they do not come in touch

with mobile parts or they are not squeezed. Also

be careful when the hob is put together with an

oven.

Important! It is important to install the elbow

correctly, with the shoulder on the end of the

thread, fitted to the hob connecting pipe.

Important! Failure to ensure the correct

assembly will cause leakage of gas.

Important! Make sure that the gas supply

pressure of the appliance obeys the

recommended values.

Rigid connection:

Carry out connection by using metal rigid pipes

(copper with mechanical end).

Injectors replacement

1. Remove the pan supports.

2. Remove the caps and crowns of the burner.

3. With a socket spanner 7 remove the injec-

tors and replace them with the ones which

are necessary for the type of gas you use

(see table in "Technical Information" chap-

ter).

4. Assemble the parts, follow the same proce-

dure backwards.

5. Replace the rating plate (it is near the gas

supply pipe) with the one for the new type

of gas supply. You can find this plate in the

package supplied with the appliance.

If the supply gas pressure is changeable or dif-

ferent from the necessary pressure, you must fit

an applicable pressure adjuster on the gas sup-

ply pipe.

Adjustment of minimum level

To adjust the minimum level of the burners:

1. Light the burner.

2. Turn the knob on the minimum position.

3. Remove the knob.