Zanussi ZGNE645K Kullanıcı Kılavuzu - Sayfa 7

Hob Zanussi ZGNE645K için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. Zanussi ZGNE645K 21 sayfaları.

Sayfayı Yazdır

Rigid connection:

Carry out connection by using metal rigid pipes

(copper with mechanical end).

INJECTORS REPLACEMENT

1. Remove the pan supports.

2. Remove the caps and crowns of the burner.

3. With a socket spanner 7 remove the injectors

and replace them with the ones which are

necessary for the type of gas you use (see

table in "Technical Data" chapter).

4. Assemble the parts, follow the same procedure

backwards.

5. Attach the label with the new type of gas

supply near the gas supply pipe. You can find

this label in the package supplied with the

appliance.

If the supply gas pressure is changeable or

different from the necessary pressure, you must fit

an applicable pressure adjuster on the gas supply

pipe.

ADJUSTMENT OF MINIMUM LEVEL

To adjust the minimum level of the burners:

1. Light the burner.

2. Turn the knob on the minimum position.

3. Remove the knob and the gasket.

WARNING! Pay attention not to

damage the gasket. Do not use sharp

tool to remove it.

4. With a thin screwdriver, adjust the bypass

screw position (A).

5. If you change:

•

from natural gas G20 20 mbar to liquid gas,

fully tighten the bypass screw in.

•

from liquid gas to natural gas G20 20 mbar,

undo the bypass screw approximately 1/4

of a turn (1/2 of a turn for Multi Crown

burner).

6. Reassemble the gasket and the knob.

WARNING! Make sure to place the

gasket exactly in the original position.

WARNING! Make sure the flame does

not go out when you quickly turn the

knob from the maximum position to the

minimum position.

ELECTRICAL CONNECTION

•

Do not pull the mains cable to disconnect the

appliance. Always pull the mains plug (if

applicable).

•

The appliance must not be connected with an

extension cable, an adapter or a multiple socket.

There is a risk of fire.

•

Do not let the power cable to heat up to a

temperature of more than 90° C. The cable

should be guided by means of clamps fixed to

the side of the cabinet, in order to avoid any

contact with the appliance beneath the cooktop.