Zanussi ZGO63414 Kullanıcı Kılavuzu - Sayfa 4

Hob Zanussi ZGO63414 için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. Zanussi ZGO63414 40 sayfaları. 58 cm, 4 zones
Ayrıca Zanussi ZGO63414 için: Kullanıcı Kılavuzu (48 sayfalar), Manuel (44 sayfalar), Kullanıcı Kılavuzu (16 sayfalar), Kullanıcı Kılavuzu (40 sayfalar)

Sayfayı Yazdır

• Carefully obey the instructions for electrical

connections. There is the risk of injury from

electrical current.

• Disconnect the appliance from the elec-

trical supply, before you do the mainte-

nance work or you clean it.

• The electrical mains terminal is live.

• Make electrical mains terminal free of volt-

age.

• Install correctly to give anti-shock protection.

• A loose and incorrect mains plug and socket

connections can make the terminal become

too hot.

• A qualified electrician must install the clamp-

ing connections correctly.

• Use a strain relief clamp on cable.

• Use the correct mains connection cable and

replace the damaged mains cable with appli-

cable cable. Speak to your local Service

Force Centre.

• The appliance must have the electrical instal-

lation which lets you disconnect the appli-

Installation

Warning! The following instructions about

installation, connection and maintenance

must be carried out by qualified personnel in

compliance with standards and local

regulations in force.

Gas Connection

Choose fixed connections or use a flexible pipe

in stainless steel in compliance with the regula-

tion in force. If you use flexible metallic pipes,

be careful they do not come in touch with mo-

bile parts or they are not squeezed. Also be

careful when the hob is put together with an

oven.

Important! Make sure that the gas supply

pressure of the appliance obeys the

recommended values. The adjustable

connection is fixed to the comprehensive ramp

by means of a threaded nut G 1/2". Screw the

parts without force, adjust the connection in the

necessary direction and tighten everything.

ance from the mains at all poles with a con-

tact opening width of minimum 3 mm.

• If the fixing bracket is near to the terminal

block, always make sure the connection ca-

ble does not come in contact with the edge

of the bracket.

• You must have correct isolation devices: line

protecting cut-outs, fuses (screw type fuses

removed from the holder), ground leakage

trips and contactors.

Disposal of the appliance

• To prevent the risk of physical injury or dam-

age

– Disconnect the appliance from the power

supply.

– Cut off the mains cable where it connects

with the appliance and discard it.

– Flat the external gas pipes if there are fit-

ted.

– Speak to your local authorised facilities for

disposal of your appliance.

End of shaft with nut

Washer (additional washer is only for Slov-

enia and Turkey)

Elbow

Rubber pipe holder for liquid gas (only for

Slovenia and Turkey)