Zanussi ZGS 645 Kullanım Talimatları Kılavuzu - Sayfa 16
Hob Zanussi ZGS 645 için çevrimiçi göz atın veya pdf Kullanım Talimatları Kılavuzu indirin. Zanussi ZGS 645 21 sayfaları.
Ayrıca Zanussi ZGS 645 için: Kullanıcı Kılavuzu (40 sayfalar)
Sayfayı Yazdır
Electrical Connection
The appliance is designed to be connected
to 230 V monophase electricity supply.
The connection must be carried out in
compliance with the laws and regulations in
force.
Before the appliance is connected:
1) check that the main fuse and the
domestic installation can support the load (see
the rating label);
2) check that the power supply is properly
earthed in compliance with the current rules;
3) check the socket or the double pole
switch used for the electrical connection can be
easily reached with the appliance built in the
forniture unit.
The appliance is supplied with a connection
cable. This has to be provided with a proper
plug, able to support the load marked on the
identification plate. To connect the plug to the
cable, follow the recommendation given in Fig.
3a. The plug has to be fitted in a proper socket.
If connecting the appliance directly to the
electric system, it is necessary that you install a
double pole switch between the appliance and
the electricity supply, with a minimum gap of 3
mm. between the switch contacts and of a type
suitable for the required load in compliance with
the current rules.
The connection cable has to be placed in
order that, in each part, it cannot reach a
temperature 50°C higher than room
temperature.
The brown coloured phase cable (fitted in
the terminal block contact marked with "L")
must always be connected to the network
phase.
16
Remplacement of the voltage cable
The connection of the voltage cable to the
appliance's terminal block is of type "Y". This
means that its replacement requires the
specific equipment of a technician. In this case,
only cable type H05V2V2-F T90 must be used.
The cable section must be suitable to the vol-
tage and the working temperature. The yellow/
green earth wire must be approximately 2 cm.
longer than the phase wires (Fig. 3-a).
To open the terminal block and reach the
terminals, proceed as follows:
insert the point of a screwdriver into the
"
visible protrunding part of the terminal block;
exert a light pressure and lift (Fig. 3-b)
"
Fig. 3-a
Fig. 3-b
Neutral
Earth
(yellow/green))