Zanussi ZGS 64IX Kullanıcı Kılavuzu - Sayfa 15

Hob Zanussi ZGS 64IX için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. Zanussi ZGS 64IX 24 sayfaları.

Sayfayı Yazdır

Electrical connection

The appliance is designed to be

connected to 230 V monophase

electricity supply.

The connection must be carried out in

compliance with the laws and

regulations in force.

Before the appliance is connected:

1) check that the main fuse and the

domestic installation can support the

load (see the rating label);

2) check that the power supply is

properly earthed in compliance with

the current rules;

3) check the socket or the double pole

switch used for the electrical

connection can be easily reached

with the appliance built in the forniture

unit.

The appliance is supplied with a

connection cable. This has to be provided

with a proper plug, able to support the

load marked on the identification plate.

The plug has to be fitted in a proper

socket.

If connecting the appliance directly to the

electric system, it is necessary that you

install a double pole switch between the

appliance and the electricity supply, with

a minimum gap of 3 mm. between the

switch contacts and of a type suitable for

the required load in compliance with the

current rules.

The connection cable has to be placed in

order that, in each part, it cannot reach a

temperature 90 °C higher than the room

temperature.

The brown coloured phase cable (fitted

in the terminal block contact marked with

"L") must always be connected to the

network phase.

Replacement of the voltage

cable

Only cable types H05RR-F, H05V2V2-F

T90 or H05 BB-F must be used. The

cable section must be suitable to the

voltage and the working temperature.

The yellow/green earth wire must be

approximately 2 cm. longer than the

phase wires (Fig. 6).

Neutral

Earth

(yellow/green))

Fig. 9