Zanussi ZBF11421SA Kullanıcı Kılavuzu - Sayfa 8
Dondurucu Zanussi ZBF11421SA için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. Zanussi ZBF11421SA 17 sayfaları.
Ayrıca Zanussi ZBF11421SA için: Kullanıcı Kılavuzu (36 sayfalar), Kullanıcı Kılavuzu (49 sayfalar)
Sayfayı Yazdır
After three hours reload the previously removed
food into the freezer compartment.
PERIODS OF NON-OPERATION
When the appliance is not in use for long periods,
take the following precautions:
1. Disconnect the appliance from electricity
supply.
2. Remove all food.
3. Defrost (if necessary) and clean the appliance
and all accessories.
TROUBLESHOOTING
WARNING! Refer to Safety chapters.
WHAT TO DO IF...
Problem
The appliance does not oper-
ate.
The appliance is noisy.
Audible or visual alarm is on.
Power indicator light is flash-
ing.
The compressor operates con-
tinually.
8
4. Leave the door/doors open to prevent
unpleasant smells.
Possible cause
The appliance is switched off.
The mains plug is not connec-
ted to the mains socket cor-
rectly.
There is no voltage in the
mains socket.
The appliance is not supported
properly.
The cabinet has been recently
switched on.
The temperature in the appli-
ance is too high.
An error has occurred in meas-
uring the temperature.
The appliance is not working
properly.
The temperature in the appli-
ance is too high.
Temperature is set incorrectly.
WARNING! If you want to keep the
appliance switched on, ask somebody
to check it once in a while to prevent
the food inside from spoiling in case of
a power failure.
Solution
Switch on the appliance.
Connect the mains plug to the
mains socket correctly.
Connect a different electrical
appliance to the mains socket.
Contact a qualified electrician.
Check if the appliance stands
stable.
Refer to "Door Open Alarm"or
"High Temperature Alarm".
Refer to "Door Open Alarm"or
"High Temperature Alarm".
Contact a qualified electrician
or contact the nearest Author-
ized Service Centre.
Contact a qualified electrician
or contact the nearest Author-
ized Service Centre.
Contact a qualified electrician
or contact the nearest Author-
ized Service Centre.
Refer to "Operation" chapter.