Zanussi ZBF22451SA Kullanıcı Kılavuzu - Sayfa 4

Dondurucu Zanussi ZBF22451SA için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. Zanussi ZBF22451SA 16 sayfaları.
Ayrıca Zanussi ZBF22451SA için: Kullanıcı Kılavuzu (16 sayfalar), Kullanıcı Kılavuzu (16 sayfalar), Kullanıcı Kılavuzu (17 sayfalar), Kullanıcı Kılavuzu (45 sayfalar)

Sayfayı Yazdır

heating. To achieve sufficient ventilation fol-

low the instructions relevant to installation.

• Wherever possible the back of the product

should be against a wall to avoid touching

or catching warm parts (compressor, con-

denser) to prevent possible burn.

• The appliance must not be located close to

radiators or cookers.

• Make sure that the mains plug is accessible

after the installation of the appliance.

• Connect to potable water supply only (If a

water connection is foreseen).

Service

• Any electrical work required to do the serv-

icing of the appliance should be carried out

by a qualified electrician or competent per-

son.

Control panel

Display

Temperature warmer button

Temperature colder button

OK button

Mode button

ON/OFF button

Display

Off

Freezer OFF indicator

Fast Freeze function

Freezer temperature indicator

• This product must be serviced by an author-

ized Service Centre, and only genuine spare

parts must be used.

Environment Protection

This appliance does not contain gasses

which could damage the ozone layer, in

either its refrigerant circuit or insulation materi-

als. The appliance shall not be discarded to-

gether with the urban refuse and rubbish. The

insulation foam contains flammable gases: the

appliance shall be disposed according to the

applicable regulations to obtain from your local

authorities. Avoid damaging the cooling unit,

especially at the rear near the heat exchanger.

The materials used on this appliance marked

by the symbol

are recyclable.

Freezer compartment indicator

Alarm indicator

Child Lock function

Switching on

To switch on the appliance do these steps:

1. Connect the mains plug to the power

socket.

2. Press the ON/OFF button if the display is

off.

3. The alarm buzzer may sound after a few

seconds.

To reset the alarm refer to "Door open

alarm".

If "DEMO" appears on the Display, the ap-

pliance is in demonstration mode: refer to

"Troubleshooting" paragraph.

4. The temperature indicators show the set

default temperature.