Zanussi ZRB23200XA Kullanıcı Kılavuzu - Sayfa 6
Dondurucu Zanussi ZRB23200XA için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. Zanussi ZRB23200XA 14 sayfaları.
Sayfayı Yazdır
After cleaning wi pe with fresh water and
rub dry.
Accumulation of dust at the condenser in-
creases energy consumption. For this reas-
on carefully clean the condenser at the back
of the appliance once a year with a soft br-
ush or a vacuum cleaner.
What to do if...
Caution Before troubleshooting , disconnect
the power supply.
Only a qualified electrician of competent
person must carry out the troubleshooting
that is not in this manual.
Problem
Appliance dose not
work
Appliance cools too
much
The food is too warm.
Interior light does
not work
Unusual noises
6
6
Possible cause
Appliance is not switch on
Mains plug is not plugged in
or is loose
Fuse has blown or is defective.
Socket is defective.
Temperature is set too cold.
Temperature is not properly
adjusted.
Door was open for an extended
period.
A large quantity of warm food
was placed in the appliance
within the last 24 hours.
The appliance is near a heat
source.
Light bulb is defective.
Appliance is not level.
The appliance is touching the
wall or other objects.
After everything is dry place appliance back
into position.
Defrosting of the refrigerator and freezer
The two compartments of this model, are "no frost".
This means that there is no build-up of frost
when it is in operation, neither on the internal
walls nor on your food.
The absence of frost is due to the continuous
circulation of cold air inside the compartment,
driven by an automatically controlled fan.
Important There are some sounds during normal
use (compressor , refrigerant circulation).
Switch on the appliance
Insert mains plug.
Check fuse , replace if necessary.
Mains malfunctions are to be
corrected by an electrician.
Turn the temperature regulator to a
warmer setting temporarily.
Please look in the initial Control
Panel section.
Open the door only as long as
necessary.
Turn the temperature regulator to
a colder setting temporarily.
Please look in the installation
location section.
Re-adjust the feet.
Move the appliance slightly.
Solution
www.zanussi.com