Zanussi ZRB34211XA Kullanıcı Kılavuzu - Sayfa 11
Dondurucu Zanussi ZRB34211XA için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. Zanussi ZRB34211XA 16 sayfaları.
Sayfayı Yazdır
Replacing the control unit
The appliance is equipped with a longlife LED
interior light.
Only service is allowed to replace the control
unit. Contact your Service Center.
Installation
Caution! Read the "Safety Information"
carefully for your safety and correct
operation of the appliance before installing the
appliance.
Positioning
Install this appliance at a location where the am-
bient temperature corresponds to the climate
class indicated on the rating plate of the appli-
ance:
Climate
Ambient temperature
class
SN
+10°C to + 32°C
N
+16°C to + 32°C
ST
+16°C to + 38°C
T
+16°C to + 43°C
Location
Warning! It must be possible to
disconnect the appliance from the mains
power supply; the plug must therefore be easily
accessible after installation.
The appliance should be installed well away
from sources of heat such as radiators, boilers,
direct sunlight etc. Ensure that air can circulate
freely around the back of the cabinet. To ensure
best performance, if the appliance is positioned
below an overhanging wall unit, the minimum
distance between the top of the cabinet and the
wall unit must be at least 100 mm . Ideally, how-
ever, the appliance should not be positioned
below overhanging wall units. Accurate levelling
is ensured by one or more adjustable feet at the
base of the cabinet.
www.zanussi.com
Closing the door
1. Clean the door gaskets.
2. If necessary, replace the defective door
gaskets. Contact the After Sales Service.
min
100mm
A
20mm
In order to guarantee proper functioning in am-
bient temperatures above 38ºC, it is advised to
have a 30mm separation between the sides of
the appliance and any surrounding furniture.
Levelling
When placing the ap-
pliance ensure that it
stands level. This can
be achieved by two
adjustable feet at the
bottom in front.
Electrical Connection
Caution! Any electrical work required to
install this appliance should be carried out
by a qualified electrician or competent person.
Warning! This appliance must be earthed.
The manufacturer declines any liability
should these safety measures not be observed.
min
100mm
B
C
11